0
One purpose for configuring a banner on a router is to assist in legal prosecution for unauthorized access. Another purpose is to provide a welcome message to users who access the router.
What else can I help you with?
What are two purposes for configuring a banner on a router?
One purpose for configuring a banner on a router is to assist in legal prosecution for unauthorized access. Another purpose is to provide a welcome message to users who access the router.
What a two purpose for configuring a banner on a router?
One purpose for configuring a banner on a router is to assist in legal prosecution for unauthorized access. Another purpose is to provide a welcome message to users who access the router.
Where is router configuration?
Configuring a physical router requires software like PUTTY. while configuring router on Software like packet tracer is done on CLI (i.e. command line interface).
What is the effect of configuring the IPv6 unicast-routing command on a router?
By configuring an IPv6 Unicast routing command on a router you are allowing the router to communicate with the IPv6 interface. This is needed if you intend to send or receive data over an IPv6 network.
When does the banner display for cisco router?
whenever you log into your cisco router....
While configuring a router network technician wants to name a router Which prompt the technician would see when entering hostname command?
Router(config)#
What is the syntax to add a banner to the Cisco router?
Router#banner motd @ MESSAGE @ Like this the syntax should u must start and end with a unique character (any)
What is the syntax to add a banner to a Cisco router configuration?
Router#banner motd @ MESSAGE @ Like this the syntax should u must start and end with a unique character (any)
What does multicasting have to do with hubs?
Multicasting can be done on a hub but a hub does not need it always. Configuring a router or switch to use multicasting requires that the router or switch be IGMP capable.
Which programs can be used to accomplish terminal emulation for configuring a router from the CLI through the console port?
HyperTerminalMinicom
When configuring RIPng the command instructs the router to propagate a static default route?
default-information originate
Is calling Linksys' tech support a hassle if I want some help on configuring my Linksys wireless router?
I have not heard anything good about the Linksys' technical support at all. Your best bet is probably to go to your local computer store and ask them to help you configuring your Linksys wireless router.
