0
What else can I help you with?
What is the vertical portion of a table in Microsoft word called?
A column.
What is the definition of vertical component?
The vertical component is the portion of a vector that points in the vertical direction, typically perpendicular to the ground or a reference plane. It is the part of the vector that contributes to motion or force along the vertical axis.
What is the purpose of the vertical portion of the fermentation tube?
The vertical portion of the fermentation tube allows gases produced during fermentation to escape without letting air in. This helps prevent oxygen from entering the fermentation vessel, which could negatively impact the fermentation process.
Where is the ruder on the airplane?
The rudder is the back portion of the vertical fin on the tail. It is hinged and moves from side to side as required by the pilot.
Why is an I-Beam stronger in its weight than a simple rectangular beam?
The vertical portion of the I-beam resists shear force better than a rectangular one. The "I" portion also deflects force because of its design.
The vertical distance of an intake or exhaust valve is called?
The question is a little vague. So i hope i give the answer you were looking for. The vertical portion of the small diameter of the valve is called the stem. The vertical opening distance is called valve lift. The entire length of the valve would be the overall length. Hope this may help?
What did the treaty of tordesilla accomplish?
The Treaty of Tordesillas settled the ongoing conflict between Spain and Portugal in 1494. It established a line vertical line 1,100 west of the Cape Verde Islands giving the eastern portion to Portugal and the western portion to Spain. This is the reason Brazilians speak Portugese.
What is the vertical wall below the crown of a landslide?
The vertical wall below the crown of a landslide is called the head scarp. It forms when the upper portion of the slope breaks away and creates a steep, vertical face as the material moves downhill. The head scarp is often a key indicator of past or potential landslide activity.
What are The vertical limits of that portion of Class E airspace designated as a Federal Airway over Magee Airport?
1,200 feet AGL to 17,999 feet MSL.
Difference between cloud base and cloud ceiling?
Cloud base refers to the altitude above the ground at which the lowest portion of a cloud is observed. Cloud ceiling, on the other hand, is the height above the ground of the lowest cloud layer covering more than half of the sky. Cloud base is the specific altitude at which a cloud starts, while cloud ceiling is the overall height of the lowest cloud layer in the sky.
What is meant by rectangular components of force?
For simplicity consider a force whose direction does not correspond to either the x- or y-axis. At the head of the force (where the arrow is) draw a vertical line to the horizontal axis and a horizontal line to the vertical axis. The force is now enclosed by the lines you have drawn and the axes and this enclosure is a rectangle. Since a rectangle is also a parallelogram this means that you have also resolved the given vector into two components, namely, the one given by the portion of the horizontal axis between the origin and where your vertical line meets that axis, and the one given by the portion of the vertical axis between the origin and where your horizontal line meets that axis. These two vectors are the rectangular components of the given force.
What is meant by rectangular components of a force?
For simplicity consider a force whose direction does not correspond to either the x- or y-axis. At the head of the force (where the arrow is) draw a vertical line to the horizontal axis and a horizontal line to the vertical axis. The force is now enclosed by the lines you have drawn and the axes and this enclosure is a rectangle. Since a rectangle is also a parallelogram this means that you have also resolved the given vector into two components, namely, the one given by the portion of the horizontal axis between the origin and where your vertical line meets that axis, and the one given by the portion of the vertical axis between the origin and where your horizontal line meets that axis. These two vectors are the rectangular components of the given force.
