0
What else can I help you with?
What IS USED TO ASSESS COMPATIBILITY WHEN HARDWARE AND SOFTWARE COMPONENTS ARE AGGREGATED TO FORM SUBSYSTEMS OR SYSTEMS?
Component testing
Difference between active and passive components?
ACTIVE COMPONENTS The components which produce the energy in the form of current or voltage are called as active components. Example:transistors etc,. PASSIVE COMPONENTS The components which stores the energy in the form of current or voltage are called as passive components. example:inductors,resistors,capacitors etc,. Mrityunjay k pandey radix computer college panna naka satna mob:-09926026201
What is an analog circuit?
the circuit which contain passive components such as (capacitor,inductor,resistance) and may also contain Active components like transistorsif there is a transistor in the circuitit is ANALOG circuit if it is used in the active modeit is DIGITAL circuit if it is used in the saturation and cutoff mode
What is static analysis tools in software testing?
Static analysis tools in software testing are used by developers as part of the development and components testing processes. These tools can help developers understand code structures and more.
What is a red box and grey box testing Where do you use these tests?
red box testing is used to test products on hardware devices, networking components like protocolss Venkat 09966180818
What is active clamp?
An active clamp is a circuit used in power electronics to improve efficiency and reduce stress on components like transistors. It is designed to absorb voltage spikes, minimize switching losses, and protect components from damage by providing a controlled path for energy dissipation. Active clamps are commonly used in applications like DC-DC converters and power supplies.
What are the methods of checking removed electrical components are fit for purpose?
To check if removed electrical components are fit for purpose, one can perform visual inspections for damage, corrosion, or wear. Testing with a multimeter can assess functionality and continuity, while specialized equipment like oscilloscopes may be used for more complex components. Additionally, reviewing manufacturer specifications and conducting performance tests under simulated operating conditions can ensure the components meet required standards. Finally, any components that do not pass these checks should be replaced or repaired as necessary.
What is Driver and Stub Modules of unit testing?
In unit testing, driver and stub modules are used to facilitate the testing of individual components in isolation. A driver is a piece of code that invokes the module being tested, simulating the higher-level components that would normally call it. Conversely, a stub is a placeholder for lower-level components that the module under test depends on, providing pre-defined responses to calls made during the test. Together, they allow for focused testing of a module's functionality without the need for the complete system.
What type of ROM testing is used to pinpoint adhesions?
Selective tissue tension testing is commonly used to pinpoint adhesions in the ROM testing process. By applying specific, controlled forces to tissues, practitioners can assess the presence of adhesions based on the range of motion restrictions and the corresponding symptoms experienced by the patient.
What prefix can be used with active?
The prefix "inter-" can be used with "active" to form the word "interactive." This term refers to systems or processes that involve active participation or engagement between users or components. Another example is "proactive," which describes taking initiative and anticipating future needs or challenges.
What is alligator clip?
In electronics, alligator clips are used to temporarily hold connections together for testing or soldering. Very often, these clips will have a vinyl insulator (boot). In dental offices, alligator clips are used to hold the bib around the patients neck.
What is the function of an environmental chamber?
An environmental chamber is an enclosure that is used for testing various environmental conditions. It is used to test the effects on industrial products and materials, biological items and electronic components and devices.
