GET THE HAYNES REPAIR MANUAL FOR THAT GROUP OF CADILLACS CH 6 HAS THRM ALL 86 to 90 Broughams were incapable of pulling DTC's through the climate control head. To perform a self diagnostics on them, you have to jump the terminals on th ALDL. Follow the instructions in the link to pull DTC's.
In order to get codes for a 1994 Cadillac STS through climate control, a diagnostic test must be run by a mechanic. Most alternative tests or guide books will not provide this information. A Cadillac dealer is the best option to obtain this code.
http://www.modifiedlife.com/1990-cadillac-brougham-car-radio-wire-guide/ this might help im having the same issue
radiator
push the off and warm buttons together on the climate control panel. Hold and release . Read codes
press off and warmer buttons on climate control center. warmer is also the pass side heat button.
ignition on motor off then press and hold "off" and "rear def." for 10 seconds on the climate control.
turn the ignition on but do not start the car. hold the Off and Red Warmer button on the Climate control panel to the right of your speedometer. hold them until the dash will flash off and on and it will then list you diagnostic codes
turn the ignition on but do not start the car. hold the Off and Red Warmer button on the Climate control panel to the right of your speedometer. hold them until the dash will flash off and on and it will then list you diagnostic codes
A. Turn the igition switch on B. Depress the OFF and WARMER buttons on the climate control panel at the same time until the segment check appears on the instrument panel. c. once the service mode is entered , any trouble codes that are stored in the computer memory will be displayed. TO CLEAR CODES A. Press the HI button on the climate control panel, this will cause the display to read ECM DATA. B. Press the LO button on the climate control panel until the display reads ECM CLEAR CODES. C. Now press the high button on the climate control panel and the display should read ECM CODES CLEAR. C. After 3 seconds all stored ECM codes will be erased.
No the climate control is tied into the electronic control system of the car which is controled by the computer. The climate control can also be used to view or display fault codes from the computer...............
Use the climate control unit. with key in on position and engine off press the off and the warmer button at the same time for about 3 seconds. the codes will be displayed. Use the fan speed switch to toggle between codes and to clear.
A.I.R Control problem air injection reaction