answersLogoWhite

0


Best Answer

A band-pass filter blocks or attenuates frequencies outside of a certain range, while it accepts frequencies from within that range. The range of frequencies it will accept is determined by its Q-factor. A filter with a high Q-factor will have a narrow range of accepted frequencies, whereas a filter with a low Q-factor will have a wide range of accepted frequencies.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

12y ago

Think of the many possible combinations of shoe sizes and widths. It runs into the many hundreds. It is exactly the same with RF bandwidth stop filters.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What kinds of frequencies can be blocked by using a band pass filter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

Can you filter a toluene solution using a vacuum filter?

Yes, but it will depend on what do you want to filter. For example, in metallocenic polymer synthesis, at the end of the polymerization the polymer is precipitated from a toluene solution and then filtrated using a vacuum filter.


Can you control voltage fluctuations by using capacitor?

By using C-filter


What is the use of the bypass capacitor CE?

They are essentially the same. You are using a capacitor to "short out" any AC while DC is unchanged. A filter capacitor is used to filter line frequency and twice line frequency from a transformer rectifier combination. A bypass cap is used on ICs and transistors to remove any high frequencies from a supply line as close to the IC or transistor pins as possible. They are similar, but the bypass cap, while also removing line frequencies, also is used to remove higher frequency spikes from the supply that can cause ICs to malfunction. The spikes can come from other nearby ICs switching state, which causes transients in the supply line. Bypass caps are usually 0.1µF 20 volts ceramic and are located as close as possible to the ICs, and you usually have one of these for each IC. Then you have one or a few larger caps, say 100µF 10 volt, per board. The 0.1µF ones remove the very high frequencies, and thus must be close to the ICs. The 100µF ones remove the lower frequencies. But, you can call bypass caps "filter caps" if you want, there is a lot of overlap. There are also "filter caps" that are used in low pass filters, so the terminology can be confusing.


How do you filter DC power?

D.C power can be filtered using low pass capacitive circuit


What is the technique used to transmit and receive multiple signals using multiple frequencies over one cable?

DWDM (Dense Wavelength Division Multiplexing)

Related questions

What is Crossover claim?

when you wanna divide your high frequencies and low frequencies by using a crossover filter


Example of pictograph?

Definition of Pictograph * Pictograph is a way of representing statistical data using symbolic figures to match the frequencies of different kinds of data.


Is swearing blocked in perfect world?

Yes. Perfect World has a filter that they're updating all the time. Not all words are blocked, but it is still advised to be careful about using them, you can still get reported. Though with all the updates, words that are not blocked at this time may end up being blocked in the future.


How do you unblock addresses blocked by NOD32 Antivirus?

advanced setup -> web access -> https -> address management -> add domain name to list of excluded from filter using * (eg *www.domain.com*)


What is the primary function of filter in electronic circuit?

The primary function of a filter is to reduce the level of, or ideally eliminate, unwanted frequencies. There are three basic types of filter:Low pass which permits frequencies below a predetermined frequencyHigh pass the opposite of low passBand pass which permits a predetermined range of frequenciesNotch which permits everything except a predetermined range of frequenciesFilters can be analogue using resistor-capacitor or indutctor-capacitor networksor digital


What cleans filter cloths?

You can get specialstuff to do this when it starts to get blocked from the pool shop. I personally have made up a bucket of fairly strong muriatic acid solution and put the filter cartridge in ti for a few hours. It worked nicely. I would suggest however that the filter cloth you are using can stand up to acid before you try it.


Probability found using frequencies in a game or experiment?

Experimental probability


When using diodes can power be trapped?

It can be blocked, but not trapped.


How do programmers access blocked websites?

Programmers are able to access blocked websites in several different ways by using the following techniques: using IP instead of URL, Anonymous Surfing, and by using Proxy in Browsers.


Why is MAC filtering better than IP filtering for your home router?

The MAC address for each devices will not change but an IP address can be reused so using the MAC address for filtering means that the device will always be included whereas the device may be blocked if allocated a new IP address which has been blocked by the filter.


How can you access blocked youtube?

Just try using yobaproxy.


Use naughty in a sentence?

A naughty user can be blocked from using this site.