0
the effects of backlash in machine slides and screws include wrong mesuremets being made and therefore this would cause the workpiece to be worng and therefore you would need to start the workpice again, this would be a waste of time and matierials. this can be overcome by ensuring that before mesurents are made that you check there is no backlash and that when you turn the handles it moved straight away, or reporting the problem to your instructor so it can be fixed.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is a bed of a sewing machine?
The bed of the machine is the part where the fabric slides under the needle.
How do you add effects to 280 slides?
In Windows Movie Maker, I would suggest using the Auto Movie feature to add effects automatically to 280 slides.
what type of simple machine is slides?
a slide is an inclined plane
What effects add pattern and texture to a slides's background which adds depth to a slide?
Fill Effects
Where are the Hyundai headlight adjusting screws?
Every Hyundai i have seen does not have adjusting screws as such, rather slides where they mount to the body. simpley loosen and adjust then tighten
Which PowerPoint that adds special effects to modify the appearance of the slides and the timing between each slide?
Power point 2007 started to add various new effects. The animations between slides can be done by 2007.
Who many ways can you add effects and animation to text or graphics in your slides?
asdasdsadsad
Which option allows you to add different effects for each of the bulleted items on your slides?
custom animation.
How do you change a tail light on a Kia Sorento?
Open hatch remove the two screws on side of tailight with hand tap toward outside of vehicle the light has plastic pin on back of light goes in slot and slides about 1/2" outside the car to remove and pushes in and slides toward the hatch to lock in and replace screws
Difference between permanent and temporary slides?
permanent slides as their name suggest the last for a long time..but temporary no,, they may be affected by temperature or some other outer effects :P
Why does a milling machine have locking slides?
Locking slides are a common safety feature found on many milling machines. These keep the piece being milled from flying away or suddenly being slung by the drill.
What causes the lathe machine taper problem?
Taper problems on a lathe can be caused by many things. Below are the most likely possible causes and solutions:Misaligned tail stock- In most cases the tail stock can be realigned with its setting screws- Worn tail stock slides - Send for repairMisaligned Head stock- The head stock can be re-alignedMisaligned bed- The entire machine should be leveled againWorn bed ways- The machine should be sent for regrinding the beds
