The work piece is tight hold in the chuck. the chuck part of the lathe machine .it is made of mild steel .clamping to hold the device to normal cutting and simple .
clamp the workpiece rigidly. no vobration of the work piece as well as cutting tool . prevent breakage of the cutting tool. physical accidents can be avoided
tbh iv been tryna find out myself.....
clamp is a holding device. The principle of clamping is " the clamping forceshouldbe strong enough to withstand forces that are caused during machining and clamping force should not be such high that it will damage the work piece".
A bench dog is a device used on a woodworking bench to hold a workpiece in place.
a jig
Vice mens, 1.A holding device attached to a workbench; has two jaws to hold workpiece firmly in place 2.A specific form of evildoing "vice offends the moral standards of the community" 3.Moral weakness
The maximum amount of voltage that a surge protector will allow through itself before it will suppress the power surge. When the device reaches its clamping voltage, it blocks any further current from flowing through the device and into a computer system or other electronic device. Source: http://www.webopedia.com/TERM/C/clamping_voltage.html
It is an electrical device with two jaws that open to allow clamping around an electric conductor. This allows the current in the conductor to be measured.
Instead of using a vice, a person could use a monkey wrench or any type of clamping device. Additionally, a person's hands will work if the pressure required is low.
A device for holding a lamp.
Tong tester is an electrical device having two jaws that allow clamping around an electrical conductor. It helps to measure the electric current in the conductor.
A hemostat is often used as a clamping device. During surgeries they are used to clamp things like blood vessels, until they either stop bleeding, or are burned.
it is an accurate device that that used for tranmitting or holding biologic liquids