Its called a heat sink
radiator is the zig zag tubing thing with metal fins in front of the engine block. you will see a metal cap on the center top sometimes on the side.
at the end of the dolphins "tail" is called a fluke
Use a white pencil eraser, it will gently remove all of the tarnish on the gold contacts :)
metal
Its Called The Computer, The Top Part Is Called The Screen The Metal Box Is Also Called The Hard-drive
A CPU typically looks like a small square with a very high number of tiny golden pins on one side, a band of green silicon around the edges, and a thick metal covering plate on top. It will usually have some kind of emblem or writing on the top.
It simply has 4 fins one on the top of his body 2 at the side of its body and 1 at the back of his body
Dorsal - Top of the fish Caudal - The "tail fin" Anal - Rear most fin on the bottom of the body Pelvic - Front set of finds on the bottom of the body Pectoral - Right behind the gills on the side of the fish's body
yes, usually mounted directly to the top of the processor is a heat-sink(piece of aluminum with fins, lots of what could be called fingers) its purpose is to dissipate(remove) heatA COOLER is a clip-on device that mounts on top of the processor; fingers or fins at its base pull the heat away from the processor.~tekno
yes, usually mounted directly to the top of the processor is a heat-sink(piece of aluminum with fins, lots of what could be called fingers) its purpose is to dissipate(remove) heatA COOLER is a clip-on device that mounts on top of the processor; fingers or fins at its base pull the heat away from the processor.~tekno
Most motherboards are the same in this regard. Your CPU should be less than 2" away from the back panel of your motherboard (Where your keyboard, mouse, USB devices, etc plug into) inside of your case. It will be covered by a heatsink (Metal fins, square aluminium box with fins, etc) and usually a fan. This shouldn't be removed unless you have thermal grease to reapply to your CPU, or if you're removing the CPU permanently.
You must be referring to the CPU heatsink/fan assembly. Modern CPUs generate so much heat that it is necessary to provide cooling in order to prevent damage. The heat sink is a metal piece which mounts directly on top of the CPU, through physical contact the heatsink draws heat from the CPU into itself. The top of the heatsink is designed to have as much surface area as possible in order to maximize heat dispersal. Usually a fan is then mounted on top of the heatsink in order to further increase its cooling ability.