0
What are the part numbers for 1965 Pontiac Catalina 389 engine mounting bracket assemblies that bolt to the frame rails?
The part numbers for the engine mounting bracket assemblies for a 1965 Pontiac Catalina with a 389 engine are typically 9778686 for the left side and 9778687 for the right side. These brackets are essential for securing the engine to the frame rails. It's always advisable to verify with a parts catalog or a Pontiac restoration expert for specific applications or variations.
What else can I help you with?
A 1986 Pontiac fiero 2.8 clutch slave mounting bracket where to find new or used?
The fireostore.com has them
Is the hard drive connected to a mounting bracket If so what type of screws secure the hard drive to the mounting bracket?
Is the hard drive connected to a mounting bracket? If so, what type of screws secure the hard drive to the mounting bracket
What is Pontiac part number 5579457?
for my 1974 firebird 5.7L 350, it is the oil filter mounting bracket (aka the housing the oil filter goes into)
What is the caliper mounting bracket bolts torque spec for an 2004 Pontiac Grand Am?
Front caliper bracket to knuckle, 85 ft lbs. I also use a drop of blue "Loctite" thread locker on clean threads.
Front license plate mounting Chrysler Sebring convertible?
There is not a front licensing mounting bracket, on a Chrysler Sebring. The Chrysler Sebring has a rear license plate mounting bracket.
Are there any fasteners holding the rotors onto the front axle of a 2003 Pontiac vibe?
No fasteners holding rotor on. But you must remove caliper and caliper mounting bracket first.
How do I install a ceiling fan mounting bracket?
To install a ceiling fan mounting bracket, first turn off the power to the ceiling fan. Then, attach the bracket to the ceiling electrical box using screws. Make sure the bracket is securely in place. Finally, follow the manufacturer's instructions to attach the ceiling fan to the mounting bracket.
What is the recommended 8 screw size for securing the mounting bracket to the wall?
The recommended screw size for securing the mounting bracket to the wall is 8.
What type of mounting bracket should be used for installing a light fixture?
A sturdy mounting bracket designed for light fixtures should be used for installation.
Where is the brake light switch on a 93 Dakota?
Just above the brake pedal, on the mounting bracket that the pedal pivots on.Just above the brake pedal, on the mounting bracket that the pedal pivots on.
How do I properly install a vanity light mounting bracket?
To properly install a vanity light mounting bracket, first turn off the power to the light fixture. Then, attach the bracket to the electrical box using screws. Next, secure the bracket in place by tightening the screws. Finally, attach the vanity light fixture to the mounting bracket following the manufacturer's instructions.
What is the bracket called that holds the caliper?
Caliper mounting bracket or steering knuckle. It depends on if the bracket is a separate part of the knuckle or not.
