first check you timing. Locate no. 1 cylinder and take out your spark plug and rotate your shaft by using the belt,position the crankshaft pulley to top dead center(TDC) to the zero mark on the side of the pulley. Then make sure the no. 1 piston is all the way up. now check the position of the rotor at the distrubutor, should be pointing at no. 1 spark plug on the dist. should be mark no. 1 on the cap of the distrubutor.
If on 2 cylinders, replace the coil, if on no cylinders, ignition control module, also could be crank sensor.
Ignition module bad.
Bad coil Distributor cap Rotor
Cars Main ComputerType your answer here...
V6 - 3.1L .045" L4 - 2.2L .045"
A bad spark plug, spark plug wire, distributor cap, rotor, fuel injector or burned valve.
=No it will not have a spark!==No it will not have a spark!=
Check your coil pack or the spark plugs.
poor spark plug gap bad wires or weak coil or bad spark plugs
A BAD CRANK SENSOR WILL CAUSE NO SPARK AND NO PULSE SIGNAL TO FUEL INJECTORS a bad ignition module will cause no spark its located under the ignition coil trio pack
Bad spark plug or wireBad valve (do a compression test)Bad piston "
Found out that I had an exposed wire lying on the arm of the gas pedal.