Switched power means the AC power will be lost if the receiver is on standby. In unswitched, the power will be supplied even if the receiver is on standby. Regards, Raghu
AnswerThere is a hard rock band called AC/DC .In electrical jargon, AC is short for alternating current and DC is short for Direct current.
Check the belt and pulleys. Make sure the AC pulley turns. When the AC is turned on, the clutch should engage to the pulley and the AC compressor should turn, and yes, it can cause the engine to vibrate a little. If the clutch doesn't try to engage, there could be some problems with the AC, but first try to find out what caused the noise, and determine if the AC compressor is turning.
Chances are. your AC is not cycling anymore. The most common reason that this happens is due to a small leak in the system that allows the refrigerant to escape and when enough has leaked out, the low pressure switch is activated to shut the compressor down to make sure that the compressor does not burn itself out. When this happens, you will notice the compressor running for a short time and then shutting off. The system needs to be recharged and then leak tested, repaired, and recharged. Generally, a fitting or a hose has leaked and once it is repaired you AC will work fine again.Honda Mans answer Low refrigerant is the most common cause of car A/C not working. Use an AC gauge set to determine the pressures. With the AC off, the pressure should be around 90-100 PSI depending on the ambient/outside temperature. With the AC on, the low side should be around 30 PSI and the high side around 250-300 PSI. If the system is low look for oily residue (possibly UV dye) on any of the AC components including: AC compressor, evaporator drain, AC hoses, condenser (in front of radiator), drier and switches in the drier or AC lines (remove electrical plugs and look for oil). There are many other things to check, but this should get you going in the right direction.
AC= Assigned Court TR= Transfer Docket
For AC Delco spark plugs part number FR5LS or equivalent, the correct gap is .035 (GM Specifications). If using AC Delco RapidFire #5 plugs, the gap is .045 (can be used for: FR3LS, FR3LS6, FR2LS, 41-603, FR3LSJ, FR4LSJ, and FR5LS)
"Switched" means that components can be switched on and off via the master power switch. "Unswitched" means that power is always on, and no switch is available to toggle this.But the term can vary with components. For example, a UPS has unswitched receptacles. That means power is connected directly to AC mains. Switching and battery backup not provided.Unswitched on some power strips (surge protector and not protector types) means an appliance that draws power from that receptacle then causes power to be switched on for other receptacles. This feature makes possible powering on a TV or computer. Resulting in power applied to the cable box, DVR, printer, or monitor. Power off that TV or computer. Then power to other receptacles is disconnected.
From what I've been told from my AC DELCO REP they are NGK plugs
It removes moisture from system.
ac delco copper Use the factory recommended plugs. AC delco 41906.
AC are the OEM spark plugs and they are excellent plugs. I would recommend you buy AC/Delco Iridium Spark Plugs. They are as good or better than any others you can buy. NGK are also great plugs and I have been told they make the AC plug but I cannot verify that.
AC plugs
AC Delco Iridium spark plugs.
All plugs are, But you should check them yourself again.
yes
Not really, It has to plug into an AC outlet and your phone would also need to have the Qi receiver built in.
I would recommend the OEM spark plugs, AC/Delco. Excellent plugs.
Have you checked it's switched on?