hi, i have a clio face lift mk 3 2009 could you give me the tyre pressure, size 195/16
The primary stage of a tire are the inner liner, body plies and side walls. If these 3 components were not in the tire the tire would not be able to sustain high pressures of air.
tire pressures can be found 1)on the tire sidewall,2)in your owners manual 3)and sometimes either in the glove box or on the VIN label inside the driversside door panel.
Clio Mk 1 - 1990-1998 Clio Mk 2 - 1998-2006 Clio Mk 3 - 2006-present Clio Mk 4 - due 2012
up to 3 persons - 33 all round fully loaded - 35 front 42 rear
You make a mark on the tire and rotate the tire one full round while counting the number of turns of the drive shaft. If the shaft turns 3 times while the tire turns once the ratio is 3:1.
Clio, MI is 187 miles from Cedar Point. That is about a 3 hour drive.
There should be a label on the inside of the drivers door that will give you one option for tire pressures for factory installed tires. If you have replaced the tires and they are not exactly the same as the ones you removed the sidewall of the new tire will give you a range that is acceptable. For longer tire life try and stay within 2-3 lbs of the max pressure.
40 PSI front and rear up to 3 passengers. Yes, 40 PSI. I had to read it twice in the manual.
All correct tire pressures can be found on two locations, Inside the drivers door on the B pillar, open the door and look where their is labels one of them will have correct tire size for the car and also pressure recomended, another location is on the inside of the Gas door. I would suggest 34 on all.
# Set all tire pressures to the recommended kPa/psi. # Turn ON the ignition, with the engine OFF. # Press the MODE button until LOW TIRE PRESSURE HOLD SET TO RESET is displayed. # Press and hold the SET button until a chime sounds and TIRE PRESSURE RESET is displayed and a chime sounds 3 times. # release the SET button and TIRE PRESSURE NORMAL is displayed.
That information is in your owners manual and has been answered on Wiki before. 1. Make sure your tire pressures are set properly. You don't necessarily have to use the manufacturers suggested pressures but at least have the same pressure on each side of the same axle. 2. With the ignition key on, press the button on the lower left of your dashboard (it's labeled 'tire pressure reset' or something similar) and hold that button for several seconds. Watch the dashboard. When the system is reset your low tire pressure warning light will blink. 3. Release the button. Note: you may have to reset the system anytime you get new tires. Tire stores are notorous for not setting pressures correctly (even when you give them a specific number). That may cause the system to think something has changed so the light will come on.
To fit a washer pump in a Renault Clio, remove the wipers and scuttle panels. Then undo the 3 nuts. Fit the washer pump and put back the 3 nuts.