Chevy Suburban
Dodge Shadow
Ford Ranger XL

What are the torque specs for 1992 dodge shadow?

121314

Top Answer
User Avatar
Wiki User
2008-06-30 17:35:45
2008-06-30 17:35:45

What torque specs do you need? Also, what size is your motor and manual or auto tranny?

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

what are the torque specs and sequence for a 1992 Nissan maxima manifold

User Avatar

Axle torque specs are as follows: Axle nut torque..............148Ftlbs

User Avatar

The Torque Specs for a 1992 Geo Prizm are 101 ft-lbs @ 4800rpm. In addition it has a capabilty of 102hp at 5800rpms.

User Avatar

The Torque specs for a 1992 Jeep Crank with bearing caps is 80 ft./bls. You will need to check your chiltons.

User Avatar

For your 1992 Nissan/Datsun 300ZX: Flywheel Torque 61-69 Foot pounds (Final torque)

User Avatar

Haynes says that the torque specs for the rocker arms is 19 ft/lbs, and is the same for both the 2.5 I-4 and the 4.0 I-6.

User Avatar

The fuel filter is under the car, mounted in front of the fuel tank on a Dodge Shadow.

User Avatar

the torque specs for valve covers on the 3.0 SOHC is 7ft/lb make sure to clean the oil and old gasket material off well and put the RTV in the corners. take great care not to roll the gasket on the rear valve cover!

User Avatar

This will depend on the speeds that you are going at, but the 1992 mitsubishi eclipse does get up to 540 horse power, so has pretty powerful torque as well.

User Avatar

http://olybrake.com/pdf/fel_pro_torque_specs_guide.pdf check this pub out. It's all in there.

User Avatar

right next to the transaxle oil pan

User Avatar

yes, it is screwed into the exhaust manifold beind the engine

User Avatar

I think it is located inside the gas tank

User Avatar

fuel tank has to come down it's inside.

User Avatar

Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.

User Avatar

haah on the steering wheel! Horn on my 1992 Dodge Shadow 2.2 non turbo is located in the engine compartment, passenger side to the left of the AC compressor bolted to the chassis.

User Avatar

If it has a distributor, it might be the pickup inside the distributor.

User Avatar

the water pump is on the bottom of the engine underneath the alternator

User Avatar

The gap for the 2.2L and 2.5L is .035 according to the hood label.

User Avatar

from the engine computer, which gets its rpm info from the crank position sensor

User Avatar

not equiped you are going to have to use the seat belt to hold it in the seat.

User Avatar

Yes but, the 92 is non lockup and the 93 is a lockup torque converter.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.