0
What are the two ways to use the ping utility to test a local computers NIC?
Wiki User
∙ 12y ago
go to command prompt and type in either
Ping Loopback, or Ping 127.0.0.1
or Ping another device's IP Address
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
A useful TCP utility to test for connectivity is?
The ping command.
Which utility should you use to test whether tcpip has been initialized on a computer?
Use Ping to the local loopback adaptor; that tests whether TCP/IP has been installed and is working on the system.
Call of duty world at war what is a ping?
Ping is the name of a standard software utility used to test network connections. In some games (I am not sure about CoD) you can get kicked from servers for 'ping too high.'
What does ping rate mean?
The ping rate is the communication delay between two computers or a computer and a network. A computer ping test can determine how fast a computer can connect to others.
Which tcpip command was designed to test the presence of a remote system?
PING utility can be used to check the existence of remote computer
What is PING used for?
The ping utility allows users to test if a host can be reached on an IP network, as well as the round-trip time for messages from a host to a destination. Response times are generally tracked in milliseconds.
How is a broadband speed test conducted?
A ping is sent out from the testing center to the computer to identify the best server to use. Then a test of the downloading from the test facility and an upload to the test facility are conducted to test the computers speed.
What is the use of ping in networking?
Ping is a computer network administration utility used to test the reachability of a host on an Internet Protocol (IP) network and to measure the round-trip time for messages sent from the originating host to a destination computer. Ping is used to identify if there is an internet connection and how fast it is.
What command do you use to determine whether you can reach another computer on the local network?
"ping" will test for connectivity to a device at the Ethernet Address Level...but that does not mean the device's software is actually talking to the network or responding to the network. "ping" WILL tell you the device is wired up and has power applied to it's network interface board.
Which of the following will test the internal loopback of a node ping 10.10.10.1?
ping 127.0.0.1
What is the ping command to send 8 packets as a test?
ping -n 8 destination
What is the command that test connectivity by sending an echo request to a remote computer?
Ping
