answersLogoWhite

0


Best Answer

Off air through your own antenna, cable and satellite.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are three ways televisions can receive electronc signals?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a digital antenna?

A digital antenna is a device that allows the user to receive digital television signals from varying distances, depending on where they live. There are three main varieties of basic indoor antennas that will allow the user with a strong television signal to receive digital signals. These are the UHF, VHF and combined UHF/VHF. There are other models for homes that receive weaker signals, including those designed for placement outside of the home.


What are three ways microwaved are used?

They are used to transmit data, TV signals, and telephone signals. They are also used in ovens and radar.


To transmit and receive signals to and from multiple nodes in a three story house?

Omnidirectional


Why do gps receivers need to receive signals from four diffrent satellites not just three?

its confusing.


What is coposite video signal?

A composite video signal is a color video signal carried on a single cable. Color video signals have three separate components plus synchronization signals. They would normally require three separate cables to carry a brightness signal (with synchronization signals) and two color signals. Composite signals combine the brightness (luminance) signal with the two color (chrominance) within a single signal. The color encoding follows certain standards - PAL in UK and most of EUrope, NTSC in North America. Composite signals were developed prior to color television broadcasting with the main aim of allowing black and white televisions to receive a color signal. The encoding technique was patented in 1938, almost a decade before commercial color broadcasts began. In the early days of color television broadcasts, most televisions were black and white and it was not practical to build a completely new transmission infra-structure for the limited number of color televisions. Since the 1950s color television has been broadcast in composite format and has not changed since. It is only in the 21st century that HD television is introducing a new signal format. Today, composite is considered to be the lowest quality available. S-video, component, RGB and HDMI all offer higher quality signals. Despite the alternatives, composite signals have remained in common use because the difference is quality is not great and they provide a simple convenient method to connect equipment.


What does TV out mean?

Normally, a connector marked as TV out is an output that carries video and audio signals for connection to another device. The connector type can vary but it is likely to be three RCA connectors or an HDMI connector.


To transmit and receive signals from multiple nodes in a three-story house what type of antenna should an access point use?

omnidirectional


How does a GPS satellite work with a GPS device?

signals from at least 3 satellites send signals to and receive signals from the gps which are then triangulated to give the exact position of the GPS unit. Most GPS units are receive only. That is they must receive positional and timing information from the GPS satellite constellation. The internal processor them computes your position based upon this data(triangulation). Generally receiving data from three or more satellite's is needed to be produce a good fix (your position) but this is also dependent upon the geometry of the satellites. The best fixes are obtained when you have signals from three or more satellites which are geometrically separated by 45 degrees.


Why is the color on my HD TV awful when DVD is being played?

There are several reasons why color can be corrupted between a DVD player and a television. Other than a fault, the most common cause is the confusion between component signals and RGB signals. RGB is frequently referred to as component but the two are not the same.RGB carries three signals that define the level of red, green and blue colors. Component uses one signal to define the brightness of the image (Luma) and two signals that define the color of the signal (chroma). Although both formats use three lines and often share the same connectors on equipment, they are not compatible.To correct the color problem, use the menus on the DVD player and the television to ensure that the output signal format is the same as the input signal format. It is likely that the color problem will disappear.


What is HD Component Video Inputs?

HD television signals are always in a component format. There are three signals that between them carry brightness and color information. Almost all domestic equipment uses an HDMI interface to carry the signal in a digital format now but there is also an analog HD component standard. The analog component connector is either on three RCA connectors or three BNC connectors. Pressure from the film and television industry has persuaded manufacturers to adopt HDMI as the only HD interface on modern equipment. As a result, HD analog component inputs to displays are virtually redundant now.


What can one see on the Wish TV?

WISH-TV is virtual channel 8 and VHF digital channel 9 offered by the CBS affiliate in central Indiana. WISH-TV offers three signals: 8.1 general CBS programming, 8.2 Local Weather, and 8.3 the VIPIR weather radar.


What kind of service that can be supplied through VGA port in LG LCD TV?

A VGA port will typically accept most computer display signals but in addition, the connector may also support broadcast rate signals that use an RGB format, i.e. three separate cables for red, green and blue signals. The connector might also support component video, a three wire video signal. Component signals are often connected with RCA (phono) connectors but the VGA connector is used in a very few cases. VGA does not support audio signals but some control information can be exchanged between the computer and the monitor. To establish the capabilities of a specific port, there is no alternative to reading the manual.