0
-can contain ports used as trunks
-identified by a VLAN ID between 1 and 1005
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How are VLANs and subnets related?
Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.Although VLANs and subnets are quite different concepts, when using VLANs, there should be a one-to-one correspondence between the two. That is, every VLAN should be in a different subnet.
What device allows two vlans to communicate?
cablez
How do you create VLAN step-by-step?
AnswerVLANs are created on Layer 2 switches to control broadcasts and enforce the use of a Layer 3 device for communications. Each VLAN is created in the local switch's database for use. If a VLAN is not known to a switch, that switch cannot transfer traffic across any of its ports for that VLAN. VLANs are created by number, and there are two ranges of usable VLAN numbers (normal range 1-1000 and extended range 1025-4096). When a VLAN is created, you can also give it certain attributes such as a VLAN name, VLAN type, and its operational state. To create a VLAN, use the following steps.1) Configure VTP. VTP is a protocol used by Cisco switches to maintain a consistent database between switches for trunking purposes. VTP is not required to create VLANs; however, Cisco has set it up to act as a conduit for VLAN configuration between switches as a default to make administration of VLANs easier. Because of this, you must first either configure VTP with a domain name or disable VTP on the switch.2) Create the VLAN. VLANs are created by number. The two ranges of VLANs are as follows: The standard range consists of VLANs 1 to 1000. The extended range consists of VLANs 1025 to 4096. Extended VLANs are currently supported only on switches running COS software version 6.1 or greater. When you create a VLAN, you have many options to consider. Many options are valid only for FDDI and Token Ring VLANs. Some of the items configured deal with options, such as private VLANs, which are discussed in other sections in this book. VLANs are created using the set vlan command for COS devices or with the vlan command in vlan database mode for IOS switches.
Suppose your company's network contains two separate VLANS?
A router
Two reason why Mercury is used in thermoters?
compatible expansion/contraction characteristics -- linear expansion and contraction for the normal temperature range; low freezing point of -38 degrees C
The network administrator wants to separate hosts in building a into two vlans numbered 20 and 30 which two statements are true concerning vlan configuration?
- TheVLANs may be named.- The network administrator may create the VLANs in either global configuration mode or VLAN database mode.
Normal ranges for glucose?
The normal range of glucose should be between 70 and 99 mg/dL while fasting. The normal range after two hours of eating should be less than 140 mg/dL.
What is a router on stick inter vlan routing?
A physical router device with an interface that routes between two or more VLANs that are attached to a VLAN network segment by a trunk link. In other words a " router on a [ TRUNK ] " which is originating from switches with independent non routing VLANs.
What are two features of VTP client mode operation?
unable to add VLANS can forward VLAN information to other swithces in the same VTP domain
What is the normal IgE inmunoglobulin range for a two year old?
My eight and a half month year old was recently tested. I don't have all the specifics on what is considered normal range at what specific age, but I was told that a normal level for him should have been 15 and that at 44 his level was definitely high.
What makes the range less desirable than the standard deviation as a measure of dispersion?
Range can include outliers that are not normal values and can skew overall data. Most relevant values can be found within one or two standard deviations on a normal curve.
This switch is to be added to the production network which facts about vlans and vtp operation can be confirmed by this output choose two?
All VLANs that are configured on this switch will be sent to all other switches in the same VTP domain. Adding this switch to the network will cause no disruption in the VTP domain operations if the rest of the switches in the same domain have a higher configuration revision number.
