answersLogoWhite

0

The area between deep water waves and breaker zone is the euphotic zone

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

What the difference between the breaker zone and the surf?

the breaker zone is where the waves are breaking while the surf is where the waves are more calm...


The area between the breaker zone and shore is called what?

The area between the breaker zone and shore is called the surf zone. This area is where waves start breaking as they approach the shore, creating rough and turbulent conditions for swimmers or surfers.


The area between the bulges of water is?

The area between bulges of water is a depression or a low-tide area. High tidal bulges have these low-tide areas which would correspond to troughs.


What is the area between waves called?

The area between waves is called the "trough" or "valley" of the wave. This is where the wave's amplitude is at its lowest point.


What is between the berm and the water you would find what part of a beach?

You would find the foreshore between the berm and the water. This area is affected by the tides and waves and is commonly where beachgoers spend their time.


What is the region between breaking waves and the shore?

The region between breaking waves and the shore is known as the surf zone. This area is characterized by turbulent water movement and breaking waves as they approach the shoreline. It is where wave energy dissipates and influences nearshore sediment transport.


The area between bulges of water in the ocean?

The area between bulges of water in the ocean is known as a trough. This is the part of the water surface that is lower between two adjacent crests. Troughs are typically found in waves and result from the alternating rise and fall of the water.


What is the area where waves break?

The area where waves break is called the surf zone. This is where the wave energy moves from deep to shallow water, causing the waves to steepen and eventually break as they reach the shore.


What is the process for performing a vacuum breaker replacement?

To perform a vacuum breaker replacement, follow these steps: Shut off the water supply to the vacuum breaker. Remove the old vacuum breaker by unscrewing it from the pipe. Clean the area where the old vacuum breaker was attached. Install the new vacuum breaker by screwing it onto the pipe. Turn the water supply back on and test the new vacuum breaker for leaks. Remember to follow any specific instructions provided by the manufacturer for your particular vacuum breaker model.


What depositional feature may be formed between high and low water mark?

A beach or foreshore could be formed between the high and low water marks. This area typically experiences the deposition of sand, gravel, and other sediments carried by waves and tides.


What is the area of Summer Waves?

The area of Summer Waves is 44,515.4206464 square meters.


What are the affecting the the height of the waves?

The speed of the wind, gravitational pull of the moon interactions with other waves time duration the wind has blown over a given area width of area affected by fetch water depth. These are some of the reasons that affect the height of ocean waves.