answersLogoWhite

0


Best Answer

There are no certain types of blinds that wont get snugged to pulled off balance when tugged to hard , unfortunately most blinds to tend to do this , but try to stay away from the cheap plastic blinds which tend to do this more .

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What blinds wont get snagged or off balance when pulled in?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How will current balance turn into savings account?

It wont unless you request a balance transfer.


Why do you need balance for horse riding?

well its the same question as why would you need balance to ride a bike. because if you dont have balance you wont get very far.


What would happen to the atom if there were no electrons?

there wont be any negative charges to balance the positive nucleus, hence atoms wont be stable


If Joy has been pulled over for speeding on a freeway The faster she was going the higher the ticket will be?

Well i might get this wrong but it was a freeway wasn't it? So she wont be pulled over..? TRUE


Why wont my dirt bike start in gear when the clutch is pulled in but it will start in neutral?

Make sure the sidestand is retracted.


I am trying to shrink my new power balance band. Will the dryer ruin its properties?

It wont shrink


Why wont a paper boat float on normal water?

Because a paper boat does not have balance to float


Where can you purchase custom blinds from?

Custom blinds can be bought from many locations. Department stores like JC Penney, Kohls, Lowes, and Home Depot all have custom blind departments. These stores will come to your house and measure the windows and sliding doors where you want the blinds. They will also hang the blinds for you at an additional charge.


How do you make a homemade spring balance?

You take a big spring and hot glue it with a wood and if you wont you can add plates you don't use then you have a home made spring balance. :)


How do you stop your washing machine from moving across the floor?

balance the load so when it spins it wont walk


After your brother-in-law and you replaced the ac unit with a bypass pully his 97 f 150 wont start it will turn over but wont start why?

Check the f150 engine on the front for any wiring that may have been pulled loose or damaged. The crank shaft sensor wires were most likely pulled loose during the bypass.


You can put direct power to your solenoid and it starts The wire you pulled off the solenoid shows power from the swith but wont start it?

Defective solenoid?