Best to just take the assembly out and look. Just one torx screw holding the assembly in. Takes less than 30 seconds to take it out. Then you know exactly what you need. Some times the gasket is sticks, I use a long screw that I put in the screw hole to grab the assembly and pull
your local auto parts store should have a guide to replacing. or look in your manual
Bulbs, switch or wiring
door button stuck --bulbs? fuse.
pop out the light assembly with a screwdriver and change the bulb. your receptacle may be taking in water at the car wash. duct tape over lens before going through automatic car wash.
You will have to remove the front bumper cover and grill to access the headlight assembly. I paid about $100 to have it done at the dealer.Type your answer here...
i got a 1993 Cadillac Coupe Deville and my turn signals was doing the same thing and I got new bulbs and still didn't work. I had to get a fuse to make them work
To change the headlamp bulbs on a 2006 Cadillac SRX, first, open the hood and locate the headlamp assembly. Remove the retaining clips or screws securing the assembly, then carefully pull it out. Disconnect the electrical connector from the bulb socket, twist the bulb counterclockwise to remove it, and replace it with a new bulb. Finally, reconnect the electrical connector, reinsert the headlamp assembly, and secure it with the clips or screws.
There are two (2) bulbs. Gently remove the plastic lens, sometimes there is a slot for a very small flat tipped tool (screw driver) to remove lens. You will then see a white plastic clip, gently push to the side and pull down this will remove the bulb casing. Twist the bulbs out. If you purchase auto part bulbs, you must bend the two electrical wires to the sides of the bulbs or they will not work. Cadillac soldered the bulbs into the plastic holders, but it is to the side not the way the bulbs come. Otherwise you will need to purchase the bulbs from a GM dealer.
To change the light bulbs on a 2006 Cadillac SRX, first, ensure the vehicle is turned off and the keys are removed. For front headlight bulbs, open the hood and locate the back of the headlight assembly; turn the bulb socket counterclockwise to remove it, then replace the old bulb with a new one, ensuring not to touch the glass part. For taillights, access the rear panel, remove the screws or clips, and pull the assembly out to reach the bulbs for replacement. Finally, test the lights to ensure they work properly.
There is a screw at the tail light that you can see by looking at it . Remove the screw and the tail light comes out by tilting it away from the body toward you, giving you access to the bulbs. Hint after you back the screw out all the way,push the screw in a little and use it as grasp the assembly( leverage) to pull the assembly away from the body. The gasket causes it to stick a little. Takes about 30 seconds to get out
To change the bulbs all you have to do is put a flat blade screw driver on the right side of the bulb housing and gently push to the left. This will release the catch holding it in and it will drop out and down on the end of its wiring connector. 1/4 turn the bulb and remove. Replace the bulb and just put the housing back into the opening left side first, then just push up on the right side till you hear a click. Takes about 1 min per light. Works for all Deville types 00-08 The only place I found replacement bulbs besides the Cadillac dealer ($32.00) for 2 bulbs was NAPA Auto Parts ($5.00) for 2 bulbs, On my 2004 Sedan Deville the release is to the left side of the housing.
Bad flasher.