There is no 'reset' button on RCA televisions of this size. Depending upon the model, there may be a factory default restore function in the menus that sets the picture and sound controls back to factory settings.
Press and old the "S" button or the "set" button until you see the volume bar on your tv. Let go of the "S" button or the "set" button. Your remote and tv are now paired.
The majority of televisions have some very basic controls on the television itself but they are normally limited to power, volume and channel change. There are often two buttons marked "up" and "down" with a mode button next to them. Pressing the mode button may allow a channel change mode although not all of them have the facility. Local controls on a television have become less important as the facilities offered by the remote have increased. We expect to be able to operate and set up a television from our armchairs. Manufacturers have responded by improving hand controls and removing controls from the television. It certainly means a more convenient control method but makes the television largely useless if the remote is mislaid. Until users demand full controls built into the television, manufacturers are very unlikely to increase the controls on the television itself.
you push the button
Use the mute button.
turn your tv on Press and hold 'SET' button while 'SET' is still pressed press 'TV' button indicator light should be on steady now press 'SET' again light should flash point control at tv and hit 'POWER' button keep pressing 'POWER' button and a different code will be sent each time. when tv switches off press 'TV' button it may take a lot of presses to find the right code!
Connect Audio out on the box to Audio In on the TV set. Make the same connection for the VIDEO. Use Input 1 on the TV then select Video 1 on the remote, Use the INPUT button.
First Hold the set button down a few seconds then at the same time without letting go of the set button, hold down the device button ie TV. Then release the set button, then the device button. Then press the set button once to start the search. The device you are sinking the remote with should switch off. If it does press the device button to store the code. If not then restart your search until it does.
If you have a TV remote then press the button 3. That is the easiest.
Mechanical (when you push a button), electrical, light, and sound
That happens in a TV set.
While your TV is on, hold down the "action" button and the "power" button located on the bottom of your TV set. Hold it for about 8 seconds. this should reset your TV.