What cable is used to connect computer to a switch?
It all depends on the interface of the switch but switches commonly use ethernet cable, most commonly Category 5 or 6 (CAT5 or CAT6).
To connect two devices of the same type together. e.g. You would use a crossover cable to connect a router to another router, a switch to another switch or a computer to another computer. If you are connecting diferent devices together, such as a router to a switch, a straight through cable should be used.
Straight Cable You usually use straight cable to connect different type of devices. This type of cable will be used most of the time and can be used to: 1) Connect a computer to a switch/hub's normal port. 2) Connect a computer to a cable/DSL modem's LAN port. 3) Connect a router's WAN port to a cable/DSL modem's LAN port. 4) Connect a router's LAN port to a switch/hub's uplink port. (normally used for expanding…
A crossover cable is used when connecting 2 computers together and a straight cable is used to connect a computer to a networking device like a network switch or router. This has to do with the send/receive pins of the cords, obviously when you need to connect 2 computers together you dont want them to be both sending through the same pin, so they are swapped so that what one computer sends comes through the…
Crossover cables are used to connect like-hardware devices or to connect anything other than a hub or switch to a computer. The crossover cable connects the four pins that are used to communicate traffic over the cable together between the two devices. Most network adapters manufactured recently can automatically sense a straight-through cable and auto-switch accordingly. All gigabit NICs are capable of this.
To set up a simple home or small office network, each computer must have a network card (NIC); you need some kind of equipment to connect the computers to (usually a switch); and each computer needs a network cable (usually UTP is used) to connect to the switch. Each computer also needs several protocols, but that should already come with the operating systems. Each computer also needs some basic configuration.
Well, You need a data cable to connect to a network. The data cable would go from your network adapter on your computer to the network. The network might be centralized by a switch, router, hub, or even a simple access point via WIFI. If WIFI is the case, then your network adapter on your computer would have to be a wireless one. Please improve or correct.