The best way to remove water from a fuel system is to add alcohol. The alcohol will dissolve the water into the gasoline an allow it to pass through the engine in very small amounts, making simple steam. In colder climates, products called "HEET" or "Gas-Dri" are available containing the appropriate amount of alcohol. In warmer climates, you may need to buy alcohol at the hardware store, usually in the paint-thinner aisle. The best is methanol or ethanol. Do not use more that 1 part alcohol to 10 parts gasoline. Also, do not use rubbing alcohol, as it contains 30% water.
The cams are worn down to far.
well there are two simple rules about anything motorized. #1......you have to have fire. #2... you have to have fuel. There is also a third rule .....you need compression , but you probally have compression since its brand new
Try redownloading it. Its done that to me alot before
dirty carb bowl or water in the carb
Hi i have a r2 motor and it got hot and then wouldnt start so i replaced the water pump as it was broke and now it wont start it winds and theres spark but wont start
do it theres so much crack floating around that city the cops wont care - Haze
usally all that needs to be done is the pcm needs reprogramed but a technition will need to do it.
take fuel filter out turn key and let pump pump it out
vovlo wont start using key
That cant be done because as long as there is water in them the temperature of the pipe wont go up enough to allow the solder to flow. you have to remove the water.
no tsunami's actually wont be noticed at sea, its as it approximates the shore when water levels start to rise
Replace the throttle potentiometerIt's on the throttle body, but I would get a Haynes manual to do this procedure.Good luck!