0
What can cause a Chevrolet Tracker 2002 headlight not to turn on?
Wiki User
∙ 14y ago
bulb, switch, fuse, ground.....
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What does a Fram PH 4386 fit?
Used on my 2002 Chevrolet Tracker.
What headlight bulb to use for a 2002 Chevrolet Silverado?
9004
Where is the pcv valve on a 2002 Chevrolet tracker?
The 2002 Chevrolet PCV valve is located on the outside of the air intake housing. The valve will be on the back of the housing.
What would cause a headlight not to work on a Corsa SXI 2002?
What would cause a headlight not to work on a Corsa SXI
Where is the 2002 Chevrolet tracker 16-pin data link connector?
It is located under dash drivers side.
What is the towing capacity for a 2002 Chevrolet tracker?
again the tow capacity for a 4x4 2002 Chevy tracker is 1500lbs but you should not tow anything without a transmission cooling system which you can purchase from your local uhaul company, if you tow with your tracker without the cooling system you will fry your transmission and damage your transfer case.
When was The Tracker created?
The Tracker was created in 2002.
How do you fix a dim headlight on a 2002 Saturn SL2?
A dimmed headlight is usually cause by a bad ground. Check the connections in the headlight wiring. Sometimes they can get water in there and just a little bit of corrosion will cause bad connection.
What would cause a ticking noise on a 2002 Chevrolet Silverado?
SEAT BELT
What are the ratings and certificates for Shark Tracker - 2002?
Shark Tracker - 2002 is rated/received certificates of: Australia:PG
What is the cause when the headlights stay on high beam on a 2002 Mazda Tribute?
headlight switch is probaly your trouble
How do you change the headlight in a 2002 Chevrolet s10?
Open the hood, stand in front of the effected headlight, notice the two tabs sticking up behind the radiator support in back of the headlight assembly. These tabs are locks that hold the headlight assembly in place. Lift the tabs up and remove them. Now you can wiggle the headlight assembly out the front and remove the bulb. Reverse for assembly.
