If you do not change a bad wheel bearing the bearing will cut a groov in the axle.If it goes on long enough the axle will have to be replaced.It could also ruin the axle housing.Then you would have to replace the rearend.
wheel bearing
Begin by removing the rear tire and wheel. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
The rear axle bearings on a Honda 300ex are replaced by first removing the rear wheel. The bearing cap and retaining ring are then removed and the bearing is then pulled from its housing.
How do you change rear wheel bearing on 1999 alero?
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
The wheel bearing
The rear wheel bearing, on a Nissan Maxima, can be removed by first removing the rear wheel. Next, remove the axle cover. Slide the wheel bearing off of the axle. Reverse the process to install the new wheel bearing.
That's never going to happen as the 98 Monte is front drive.
The rear wheel ball bearing is $86 and you are looking at 1 hour of labor at whatever labor rate is by who is doing the work.
Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
How do I put a wheel bearing on with out a wheel bearing press