Want this question answered?
You should be able to use a cupcake pan to make a gelatin mold. You might want to put wax paper in the pan though or just get a gelatin mold.
get crayons, bowl, mold,knife cut all the paper of the crayons use as many as u want. after that use a knife or a cheese greater which i use its really easier. then cut them into little chunks as possible then put all the stuff in a safe proof microwave bowl heat it on high for 1 min. or until liquidy then pour it in ur mold over night or until really hard take it out of the mold then skate
Yes
it can make us sick
not really hard at all you just put the log in and make sure you watch that it do not bound out
Use a towel, wipe them off, then put in an open container in the fridge. DO NOT put in the freezer. cut off any mold before putting with other chanterelles; mold can spred.
Put the seeds in a paper envelope. If you put them in a sealed container, use something to prevent mold.
the Iroquois did use trees but they cald them bark. they put it on water to make it soft and make it in shaps they needed to make the house they made it dry so it can be hard again the Iroquois did use trees but they cald them bark. they put it on water to make it soft and make it in shaps they needed to make the house they made it dry so it can be hard again
No - Alcohol won't freeze, so you can't make a frozen shot glass out of booze. However, you can either use a mixer (fruit juice, tonic water, etc) and freeze it in the shot glass mold, or make a gummy shot glass by melting 4 ounces of gummy candy in the microwave for 1 minute and then pouring that in the mold (4 ounces per glass). Regardless of what kind you make, freeze the mold and contents until solid, then pop it out and fill it with whatever beverage you'd like to imbibe in.
No. High impact polystyrene is a very hard plastic. If you tried doing a lost-foam casting you'd just make a mess.You make a lost-foam casting by creating a styrofoam model of your finished piece, packing casting sand around it to create a mold, then pouring metal into the mold. When the hot metal touches the foam, it vaporizes.You could make your model out of high impact polystyrene then use that to create a cope and drag mold.
For the most part, towels, rags and sponges are used to remove mold from homes. Also spray bottles that hold the solution that is being used to clean the mold.
Lady Jane cheeses are made using a mold not a bacteria. They use a strain of the Penicillium mold.