Maybe you just need a tune-up. If that doesn't work, make sure the a/c clutch is actually working and not froze up. If it's not spinning and is locked up, it could cause a load on the engine and stop it.
lower right (passenger) side in front of the engine ( tensioner is right below & behind it)..
YES
Low pressure line\ Larger hose from the compressor
If its from 85 then its NOT a geo metro engine. It is probably a Chevrolet Sprint engine because they only started making Geos in 88. If you need an engine for your 95 Geo then you could use one of the following: 1991 - 1995 Geo Metro engine. 1991 - 1995 Suzuki Swift Engine, and 1991 - 1995 Pontiac FireFly engine. Hope this helps :)
The 1998-2000 Chevy Metro with 1.0L engine has an oil capacity of 3.5 quarts.
The engine of a 1996 Geo Metro weighs approximately 150 to 200 pounds, depending on the specific engine type and configuration. The Metro typically came with a 1.0L or 1.3L four-cylinder engine. This weight is relatively light compared to many other engines, reflecting the Metro's design as an economical and fuel-efficient vehicle.
you will need to compare the engine code stamped on the engine block, and then you will need a book/manual that will tell you if they are compatible or not.
No, the 3-cylinder Geo Metro engine is not an interference design engine. This means that in the event of a timing belt failure, the pistons and valves will not collide, preventing potential engine damage. This design characteristic makes the Geo Metro's engine more forgiving in terms of maintenance and timing belt replacement.
where can you find an engine diagram of a geo metro 3 cylinder 1.0L engine
The geo metro was a version of the Suzuki Cultus that was produced from 1989-2001. The geo metro came with a 49 horsepower engine.
that must be some metro to have a big block
you dont adjust a tension pulley you adjust the position of the compressor to tighten the belt