Maybe you just need a tune-up. If that doesn't work, make sure the a/c clutch is actually working and not froze up. If it's not spinning and is locked up, it could cause a load on the engine and stop it.
lower right (passenger) side in front of the engine ( tensioner is right below & behind it)..
YES
Low pressure line\ Larger hose from the compressor
If its from 85 then its NOT a geo metro engine. It is probably a Chevrolet Sprint engine because they only started making Geos in 88. If you need an engine for your 95 Geo then you could use one of the following: 1991 - 1995 Geo Metro engine. 1991 - 1995 Suzuki Swift Engine, and 1991 - 1995 Pontiac FireFly engine. Hope this helps :)
The 1998-2000 Chevy Metro with 1.0L engine has an oil capacity of 3.5 quarts.
The engine of a 1996 Geo Metro weighs approximately 150 to 200 pounds, depending on the specific engine type and configuration. The Metro typically came with a 1.0L or 1.3L four-cylinder engine. This weight is relatively light compared to many other engines, reflecting the Metro's design as an economical and fuel-efficient vehicle.
you will need to compare the engine code stamped on the engine block, and then you will need a book/manual that will tell you if they are compatible or not.
where can you find an engine diagram of a geo metro 3 cylinder 1.0L engine
The geo metro was a version of the Suzuki Cultus that was produced from 1989-2001. The geo metro came with a 49 horsepower engine.
that must be some metro to have a big block
yes, if it's a 3 cylinder Mr Geo Metro yes, if it's a 3 cylinder Mr Geo Metro
you dont adjust a tension pulley you adjust the position of the compressor to tighten the belt