I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off.
You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.
The heater core can be removed from a 2001 Chrysler Sebring by taking it off its mounting. This is done by removing the dash.
The center counsel on a 2007 Chrysler Sebring can be removed by loosening the bolts on the bottom of the Council. The bolts are located at the back of the Council.
Maybe a blown fuse ?
engine needs to be removed
It can not be removed or disabled.
The engine and transmission are both removed out the bottom.
The factory alarm is built into the body and engine computers and can not be removed.
under the driver side front fender the wheel must be removed for access.
The fuel pump is inside the fuel tank. The tank has to be removed to access.
It is behind the rear seat back. The seat has to be removed to access.
The factory alarm is an integrated part of the computer system of the vehicle and can not be removed.
The driver side front tire, and inner fender liner need removed.
The engine and transmission are removed together out the bottom.The engine and transmission are removed together out the bottom.
It is inside the fuel tank. The tank needs removed to access.
Depends on what you are trying to drain ... please be more specific on which fluid needs to be removed.
Shop vac. There are plugs in the rear wheel wells which need to be removed for the water to drain.
The heater core is inside the HVAC housing under the dash. The entire dash has to be removed to access.
Down the middle of the valve covers. On a V6 the intake has to be removed to access the rear three.
Yes. The fuel tank must be removed to access the pump.
The thermostat for a 2004 Sebring Convertable is in under the water outlet for the BOTTOM radiator hose. This is behind the alternator which will have to be removed, after you remove the belts. Plan on an afternoon of work. Hope this helps.
The most common window problems in a 2007 Sebring are the fuse, the relay, the switch, and the motor. Check the fuse and the relay. If they are ok then the door will have to have the panel removed to reach the switch and motor.
Do your lights stay on? On my 2005, the lights go automatically off when the ignition is shut off.
The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.
The type of batter needed for a 1998 Chrysler Sebring LX is a 12 volt or 525 cranking amps battery. The batter is located in the front of the driver side wheel well under a plastic shield that will need to be removed. You will need to turn your steering wheel all the way into the left position to access the battery.
2000 Chrysler sebring,to replace battery car must go to dealer to have fender removed so new battery can be installed, they charge $169.00 for this work. Or they remove it through the hatch in the wheel well. Turn wheel fully left. Disconnect terminals. Remove the panel from the left wheel well. Remove the battery hold-down