Heater Cores and Blower Fans
Nissan Sentra
Car Heaters

What causes an ac-heater in a Nissan Sentra to only blow on high?

282930

Top Answer
User Avatar
Wiki User
2005-12-04 05:59:50
2005-12-04 05:59:50

you need a new blower motor resistor

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

More than likely the blower motor speed resistor burned out.

User Avatar

i put ad battery cable on wrong and it blow sum of da fuses were can i slove this problem

User Avatar

The pressure of the sun causes the wind to blow.

User Avatar

When you were replacing the cd player you might have sparked a wire causing the dash light fuse to blow. Check the gas light fuse in the fuse box.

User Avatar

Helium causes the balloon to blow up.

User Avatar

it sounds to me like a compressor problem. check the belt make sure it's the right size and that it is not sliping. on the electrical side of your question the compressor has a clutch on it which is electrical. the clutch has to activate so the compressor could do its work.(i doubt is the clutch)

User Avatar

Hey Alicia==There are several things wrong that have to be checked out to determine the problem. No sensors probably are bad just relays and switches, Good luckJoe

User Avatar

the winding in the fuel pump is more than likely burnt out, or the brush's inside it are stuck, you would be safer replacing than atempting to repair

User Avatar

A short to ground causes all fuses to blow. If you have a trailer connecter then start there first.

User Avatar

If it does blow just not cold air you should see if it needs to be recharged

User Avatar

Air masses change in temperature

User Avatar

Generally, a hard blow to the abdomen.

User Avatar

Over heating can blow a head gasket

User Avatar

What source: Energy From where: Sun

User Avatar

There must be a short in the system somewhere that causes the fuse to blow.

User Avatar

Fuses blow because of a over-current (short circuit) or over-heat condition. Look for a short circuit in the tail light circuit. It is also possible that the terminals at the fuse block are corroded, causing heat, which might be causing the blowing out, but highest probability is a short circuit.

User Avatar

When your hand takes a big blow of force pressure causes to burst

User Avatar

Blow by is caused when combustion gases get past the piston into the crank case. The cause will be piston, rings, or cylinder wall.

User Avatar

hold down the lock and unlock button on your keypad


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.