Have system scanned if check engine light is on. I would check for vacuum leak and if none were found do a tune-up if due. May need a fuel system check ,,,,fuel regulator, fuel injector, fuel filter. Could be throttle position sensor or crankshaft position sensor. Could be a computer problem.
Could be the Throttle Positioning Sensor or the Idle Air Control Valve
Acceleration Cable broken broken, you dump!
Adjust the idle screw.
A 350 engine will idle good but cut out and run rough while driving if there is a vacuum leak. This causes too much air to enter the engine under load.
zyou tps might be bad
On my Chevy truck it idles high when its low on antifreeze but if its not that more than likely its usually a vacuum line loose or cracked. good luck.
yes it could be that but i had the same problem on mine too and it was a leak in my intake manifold gasket, it only costs about 10 on eBay and replacement is somehow difficult but it can be done, after that, everything was working awesome!!
If the engine idles and revs up okay in neutral, it is likely the torque converter clutch lock up solenoid.
It sounds like your speed sensor is going bad. It is located below the air tube that connects the air cleaner to the intake manifold, on the passenger side, on the transmission.
why does my 4.75 BRIGGS & STRATTON lawnmower engine idles high and low when cutting my grass
When you turn on the headlights of any car it causes a load (or horsepower drag) on the engine. Your car has an idle problem and the load on the alternator simply exacerbates it.
Need a little more info. What Model and year of the vehicle?