High Pressure.
Mine is a 54 Plate with 112000 on it and still going strong. About to change the copper injector washers, I'm getting a bit of injector blow back.
I want to clarify if you are asking if you can blow air through a fuel injector? If this is your question, I am not really sure what you are going to gain by trying to do this. A fuel injector has a tiny valve inside that opens with an electrical pulse from the PCM. Even if you could open that valve, the passages inside the injector are the size of a pinprick. There is nothing to be gained in trying to blow air through an injector. You will not even be able to tell how much air is going through the injector, and how much air is going around the injector as you are doing this. If the injector will not clean up with injector cleaners, then it will require replacement.
there are many causes of blow by. these are listed as follows 1. the main cause is piston rings. the compressed gases past the piston rings and enter the crankcase . so parameters like ring waviness , thickness , tensile strength should be checked. 2. valve seat , gasket , injector seating place should be checked because these parameters also increase blow by.
The pressure of the sun causes the wind to blow.
Black smoke is : too much fuel and not enough air, a faulty injector (s). Take out the injectors and have them tested before you do engine damage.
your injector is probably shorted internally. uncommon but not unheard of
Make sure your windows are right up and the back door totally closed as the air sensors in the cabin causes the horn to blow.
You need to buy a programmer to turn the pump up.
A short to ground causes all fuses to blow. If you have a trailer connecter then start there first.
Bad pisten rings
What source: Energy From where: Sun
What source: Energy From where: Sun