0
What else can I help you with?
What makes the engine warning light come on 2001 Audi tt turbo?
Emissions related or a misfire. Get the codes read with a scanner.
What vehicle does a fram oilfilter PH8994 fit?
2008 Audi a-4 4 cylinder turbo
2001 Audi a4 blinking check engine light?
A blinking check engine light means an engine cylinder misfire has been detectedNot only a misfire, but a condition that could cause a catastrophic failure of the catalytic converter. The injector on the effected cylinder(s) will be shut off by the PCM
Is an Audi 1.8 engine the same as a Audi 1.8 turbo engine?
The 1.8 turbo is more powerfull. The turbo charger pushes more air and fuel into the engine.
Where is the turbo on an Audi A4 5v turbo?
Attached to the exhaust manifold... Follow that and you will find the turbo.
What kind of turbo is in a 2001 Audi a4 quattro?
The Turbo found in the 2001 Audi A4 Quattro is made by KKK and is the K03 version.
How much cost to fix a cylinder misfire for audi 2002 A6?
1st you have to determine the cause of the misfire: could be as simple as a gad spark plug or wire or bad ignition coil or as involved as a bad piston or valve. do a compression test to see if the misfire is caused by an internal engine componet. IF compression is within limits then problem is probably an electrical problem.
Where is turbo boost sensor on Audi a6?
a6 2005
What to expect if the turbo on a diesel Audi is on its way out?
pure awesomeness
Where is the turbo on 2002 on a Audi a4?
Turbo position is on the right front next to the p/steering pump if your A4 is a turbo unit if not it mite be a A4 L only no turbo specification. You can not install turbo because the piston are different from the turbo engine.
What kind of brake fluid does a Audi A6 2.7 liter Turbo use?
DOT 4. Is the recommended brake fluid by Audi.
How do you replace a head gasket on a Audi a3 1.8 turbo?
To replace the head gasket on an Audi A3 1.8 Turbo, start by disconnecting the battery and draining the coolant. Remove the intake and exhaust manifolds, along with the timing belt and any necessary components to access the cylinder head. Carefully unbolt the cylinder head and lift it off, replacing the old gasket with a new one, ensuring the surface is clean. Finally, reassemble the engine in reverse order, torqueing the head bolts to the manufacturer's specifications.
