bad battery. it gives off the rest of its power when its about dead. and that's what causes surging
on the 89 dynasty, it is located right next to the thermostat
on the 89 dynasty, it is located right next to the thermostat
The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.
Its located in the gas tank.
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
The engine computer is the voltage regulator.
The fuel pump surging at first could be caused by the fuel pressure bleeding off and the pump has to build the pressure up.
The only recall I found was: 181 3.0 SOHC engine: 12/93 Excessive HC emissions
The firing order for a 1988 Dodge Dynasty, equipped with a V6 engine, is 1-2-3-4-5-6. This order is crucial for the proper functioning of the engine, ensuring that each cylinder fires in the correct sequence. If you need to troubleshoot or perform maintenance, following this firing order is essential for optimal performance.
The Dirtwater Dynasty - 1988 is rated/received certificates of: Australia:M
Surging at a steady throttle around 2500 RPM in a 1988 Fiero GT can be caused by several factors, including a malfunctioning throttle position sensor (TPS), vacuum leaks, or issues with the fuel delivery system, such as a clogged fuel filter or failing fuel pump. Additionally, ignition system problems, such as worn spark plugs or faulty ignition coils, can contribute to inconsistent engine performance. Checking these components systematically can help identify and resolve the surging issue.
The Dirtwater Dynasty was created in 1988.