Mercury Mountaineer
Toyota Tacoma
Ford Ranger XLT

What causes the alarm to sound continuously on a 1997 Mercury Mountaineer?

676869

Top Answer
User Avatar
Wiki User
Answered
2005-12-01 20:34:23
2005-12-01 20:34:23

voltage drops on a weak battery can cause the alarm to trip. Whenever power is interrupted, even for a short time, the alarm will trigger. Sometimes not right away, but usually after the first drive after the power failure.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


looking for a diagram for 1999 Mercury Mountaineer. Need to take the fuse out for the seatbelt alarm, it will not shut off.

The Mercury Mountaineer is a classy SUV. Some models have been known to have faulty alarms that either go off randomly or fail to go off when they should.

my alarm goes off at random times. i had the alarm module changed for $700 and it still goes off. come home from work at 4 and it goes off at 10. before the alarm module was changed it went off at 12, 2 and 4 in the morning.

I've had that happen in my 2002 mountaineer. what I've found is that if you spray the door latches with wd40 it will clean off the sensors and the door ajar light should go out. but make sure all the doors are shut.

Are you sure you're setting the alarm and not accidentally hitting the panic button?

a constant beep is the overheat alarm a beep that goes in and out is low to no oil alarm

to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.

Don't. many try to to do that to install aftermarket alarms but since that is part of ECU programming many have never ending problems as a result. Add on to it if you need more or add a lojack. If you need to reset, an auto locksmith can do it easily.

You can disarm your 1997 Mercury Cougar alarm system by removing the alarm system fuse. The alarm system fuse can be found in the fuse box.

It would depend on the alarm, a steady alarm indicates an engine over heat. If the engine alarm is a series of beeps, this would indicate an oil pump / supply failure.

To disable the factory alarm on a 2000 Mercury Villager, put the key in the ignition and turn it halfway. Let it stay in the spot for 10 minutes and start the car.

We do not provide information that could be used to commit criminal acts. If it is your vehicle, check with the dealer service department.

How can i disable alarm activated on 1996 mercury villager Horn and location this part please How_do_you_disable_factory_alarm_activated_on_1996_mercury_villager_Horn_headlight_are_blinking_continously.

de-fuseRemove the fuse marked security, or alarm from the fuse panel fuse location?

i don't think that is a legal question...

put the key in the door and turn it to unlock

you have to unlock the passenger door from the outside with the key

To disable a factory installed alarm on a 1999 Mercury Cougar, place the key in the ignition. Turn the key only halfway and let it sit in that position for 10 minutes before starting the vehicle.

Answer for crazy alarmmy 1997 Nissan altima is similar when i park the car and lock the dorrs its fine when i return to the car and open the door with the key the lights start flashing and the horn/alarm starts going off when i put the key in the ignission the alarm stops... very intresting and wierd......


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.