0
What causes the high speed fan to keep running on 2002 windstar?
Wiki User
∙ 11y ago
The switch had a meltdown or the high speed relay is stuck.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the correct fuel pressure output for a 2002 ford windstar?
It is 28-45psi with engine running and 35-45psi with key on engine off.
What year will fit a 2002 windstar van?
2002 obviously
Where is the ecu on a 2002 ford windstar?
The 2002 Ford Windstar ECU can be found on the firewall in the engine compartment. The ECU will be on the drivers side of the firewall.
Which is the capacity of fuel tank on Windstar 2002?
According to the 2002 Ford Windstar Owner Guide : ( 98.4 liters / 26.0 U.S. gallons )
Can you put valvoline 10W30 in a 2002 ford windstar?
I was looking at the 2002 Ford Windstar Owner Guide and it shows : ( 5W-20 is recommended )
Why is there no fire in the fuse box on the left side of a Windstar 2002?
There is no fire in the fuse box on the left side of a Windstar 2002 because there was no overflow of current.
What is the fuel tank size for the 2002 ford Windstar?
According to the 2002 Ford Windstar Owner Guide : ( 98.4 litres / 26.0 U.S. gallons )
Will the interior of a 1998 Windstar fit into a 2002 Windstar GL?
Not very likely - the Windstar was significantly redesigned in 1999, and the dimensions of the vehicle were changed.
What does yellow exclamation light above speedometer in a 2002 ford windstar indicate?
That's your LOW tire pressure warning light in a 2002 Ford Windstar
Which fuse is for cigarette lighter on 2002 ford windstar?
In a 2002 Ford Windstar : ( # 17 ) is a 20 amp fuse for the cigarette lighter / powerpoint and the Datalink connector
Where is the speed sensor located on a 2002 Ford Windstar?
Friend: I sent my car to fix the moufle. After that some problems with the transmission began. The speed sensor was disconected by accident. The car was running on first and secong shift only. The computer show me the problem... The speed sensor is desconected. This sensor is so hard to reach. This is located between the exaust manifold and the monoblock wall. You need rise the vehicle and move you below it. Is not possible to see the connector, but you can see part of the sensor wall. If you see the right axle there is a mounted deviced located over it. this is the speed sensor. You can not see the connector, but you can feel it with the fingers ends only.. After two hours I had the speed sensor connected again and the car is running with no problem again. My windstar is very sensitive for this sensor.
What is a pcm on the 2002 windstar?
Powertrain Control Module
