answersLogoWhite

0


Best Answer

1) Voltage overload due to bad ground connections, or possibly other open or short connections.
2) Heat. Lack of proper heat sink compound (when mounting certain types) or lack of proper ventilation.
3) poor quality replacement parts.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What causes the ignition control module to go out?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What causes ignition control module to go bad?

depends on early or late model. lots of early models will just shut off while driving down the road etc, and never start again. cant rmember right now on late ,mind is on another project, sorry


Where is the ignition control module on 1994 Ford Van E250 6 cylinder?

The only way I can explain it is to follow the wiring from your coil pack (where the spark plugs are) and the wires plug into the ignition module. Also go go www.wrenchead.ca and it has a manual that explains all. if you don't know the answer to a question please keep your moth shut ,please don't waste my time


You have an 1989 old 88 with 3.8l Ignition control module appears to have gone bad melted grease like substance oozing out Is this a symptom of something else or is the module just failed?

your control module did go out.


Where is ignition control module on 2002 Saturn SL2?

In the front of the motor by the transmission dipstick. This is where your spark plugs from the engine go.


Where is the ignition module on an 1987 Crown Victoria?

the ignition module is on the distributer(the thing all the spark plugs wires go to)


Where is the ignition control module located on a 1992 Chevy Berretta?

ignition module is located under the distributor, where the spark plugs come out to go to the spark plugs, remove 6 bolts that hold the 3 capped distributor on, unplug the wires from both ends of module, 3 plugs, lift module out, nothing holds it in after distributor is removed, plug new module in, replace distributor.


Where is ignition module on a 1997 mercury mystique?

Hey there, I'm looking at the service manual for Contour/Mystique right now and it says the automatics have a separate ignition control module and the ignition control module for standard transmissions are fully incorporated into the vehicle computer.You mean your after market manual.There is no module in a 1997, auto trans or stick. My crank sensor was getting no voltage to it and i spent a day looking for that module,come to find the wires that connect to the sensor go directly to the computor. Im sure there is a module in one of the years the manual covers for auto trans but not a 1997 2.0 contour/mystique.


What makes an ignition module go out?

in a lot of cases its the ground connection or the grease is missing under the module


1989 Camaro eat 3 ignition modules in 7 days so what causes the ignition module to go bad in a day or two?

What exactly is going on with the car that is making you believe that the ignition module is bad to begin with? Does it not turn over, no power, are there any lights that come on the dashboard? What kind of key is used in this car? Does it have a "chip" in the key?


How do you replace the Ignition Module in the Chevy Celebrity?

To replace the ignition module in your Celebrity: Unplug the wires, take note of where they go so you can put them back in the correct place. Remove the screws that hold the ignition module in place. If the old module was coated with dielectric grease on the mounting surface put fresh dielectric grease on the replacement ignition module. Put the new ignition module in place and attach with the screws. Plug the wires back in their respective places.


Where is the ignition module for a Pontiac Grand Am gt at?

Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.


How do you install a voltage regulator on an EZ Go electric golf cart?

The regulator is attached to the wires coming out of the starter / generator, and depending on year, may be integrated into the ignition control module(ICM).