Want this question answered?
There is no configuration with that amount of wires. Proper connection requires three wires and a ground.
No, a 30 amp shore power plug is strictly 120volts. A 50 amp shore power plug is technically a 220v system, however the camper uses the two 120v wires in the cord separately. There are no 220v appliances in RV's today.
Generally, a 15 amp plug.
The diameter of aluminum wires will be 85 mm squared and copper wires will be 127 mm squared for AC current 200 amp.
Yes. Assuming everything is wired correctly and your 30 amp AC cord is compatible with your 50 amp plug, you can do this. I think you will find, however, that your 50 amp plug has a different pin configuration than your 30 amp cord end. This is not easily resolved because there are serious dangers in going the other direction, plugging a 50 amp appliance into a 30 amp receptacle.
the alpine 7914 is pre-amp only you need a amp
What is a 20 amp female transfer switch? I have never heard of such a device.
There is no configuration with that amount of wires. Proper connection requires three wires and a ground.
No, a 30 amp shore power plug is strictly 120volts. A 50 amp shore power plug is technically a 220v system, however the camper uses the two 120v wires in the cord separately. There are no 220v appliances in RV's today.
Go to this site http://www.generatorjoe.net/html/nemaplugs.html and tell me what configurations you have and I might be able to help you.
Nothing, just plug it in. Although the generator has the ability to produce up to 30 amps, the light will only pull 15, this will allow you to utilize the generator to run other items as well...
The wires in the plug are backwards. switch them around
well you plug your sub into your amp you do have an amp write
Generally, a 15 amp plug.
if you have aftermarket stereo it is very easy pull the stereo out of the dash and take your rca wires and plug them in to the back of the stereo and then take your blue wire which is remote wire and conect it to the remote wire on the back of the stereo, from there you rum the wires to your amp. ground the amp and hook up the sub to the amp and you are good to go. hope this helps.
Depends on the wire size you are using. If the generator breaker is a 30 amp then install a 30 amp breaker.
When the term "double 20 amp circuit" is used, the presumption is that, it is 20 amps at 240 volts. If your generator has the breaker built in then, yes, you have the capacity to run 240 volt devices from your generator.