0
Loopback plug
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Write the command that will allow to configure the networking card using a command line utility?
In Linux, you can configure a network card (it;s IP address, and if it is turned on or off) with the 'ifconfig' command.
Loopback command for wireless network card?
ping 127.0.0.1
Which command is used to advertise the network 150.12.32.0?
To configure EIGRP to advertise specific subnets only, use the "wild card mask" option with the network command.
How do you test network connectivity and Network Interface card functionality?
Testing the network card itself involves running a diagnostic program that is usually supplied by the vendor that manufactored the card. For basic network connectivity you can start with the 'ping' command move up from there depending on what is found.
What are agp card and lan cards?
An AGP card is a graphics or display card and will allow output to a monitor. A LAN card is a Network Interface Card which allows a computer to communicate over a network, either wired or wireless.
What is the primary use of the PING command?
To check the network card and its connection.
Which command-line utility enables you to view the address assigned to your network card?
go to command prompt n type ipconfig /all
What should you do if your network card is detected in Windows but not in Linux?
You can use a program called NDISWrapper. It will use the Windows driver for your network card and allow it to be used in Linux.
How do you test a Ethernet port?
to check if your Ethernet card r INTERNET is working r not, just type the following in command prompt: ping 127.0.0.1 This command is basically used for self test of NIC(Network Interface card) card
Does a network card allow a certain type of disk drive to be connected to a computer system?
yes
What do you mean by health card?
It is a card that comes along with your health insurance policy. Similar to the identity card, this card will allow you to avail cashless hospitalization at any network hospital.
What is purpose of command ping?
ping is a test command. It sends a "ping" to a specified IP which should ACK back, when the ACK is received the message turnaround time is calculated. If the IP fails to respond it times out and reports failure. You can use this command to verify network connectivity, etc.
