Want this question answered?
Ethernet 0/0 is down, line protocol is down
Even a slow Ethernet network would be faster than ADSL, since 10baseT LAN networks run at 10 Mbps. An ADSL connection typically tops out at around 8 Mbps. However, if you are talking about throughput, then they might be very close, since Ethernet has problems with packet collision. Then again, most Ethernet networks today for LANs run at 100 Mbps, which would place it far faster than ADSL based on speed measurements. However, ADSL does not use the same transmission method as Ethernet, but Ethernet will still be faster than ADSL (especially if you consider the Gigabit speeds).
Command to change the IP address on Linux is ifconfig.Run ifconfig to find the interface name for the connected Ethernet card. If there is only on ethernet card present on your system then the interface name would be eth0. If there are more than one Ethernet cards present on your machine then they interface names will be ethn.Once you have figurred out the interface name then ifconfig command can be used to modify the IP address$ ifconfig eth0 upeg$ ifconfig eth0 192.168.1.100 upWould assign new IP address to eth0
form_title=Ethernet Cable form_header=Connect to the internet with an ethernet cable. How many ethernet cables would you need?= {(),1,2,3,4,5,6,7,8,9,10} How long do the cables need to be?=_ Where do you need the ethernet cables?=_
Switches store the MAC addresses in an internal database called MAC Address Table. The entries in that table can be addresses learned by the switch or that can be entered manually by the switch administrator. This table is analogy to a router's routing table, only a switch operates at layer 2 whereas the router operate at Layer 3.
Washington was a volunteer at the time. He was very active in the battle afterwards, rallying the troops. Whether he could actually be considered to have taken command, as there were numerous British Officers that would have taken command rather than let some colonial take command.
Somewhere that has been sterilized. You can use an autoclave, irradiation or certain chemicals to kill microbes on surfaces. An example would be surgeouns gloves which are irradiated in their packets before use. Inside the packet there are no microbes, once they are taken out of the packet microbes in the air will begin to settle on them.
"An ethernet cable splitter allows you to connect two computers to one ethernet connection. Once you have your splitter made, you plug it into both computers just as you would with a normal ethernet cable."
The information found in the Ethernet frame trailer would be the error checking code.
You would need the ethernet card can handle gigabit network traffic cable.
Nopes, definitely no. I would rather say that "Packet Filtering" is the primary job of a Firewall.
cat 5 Ethernet cable