interface serial x/x
ip address x.x.x.x x.x.x.x
no shut
clock rate xxxxxxx
end
the interface which is used to see the commands in serial communication with external devices in a windows operated PC.
plague
Generally the keyboard. The mouse can also be used if the commands are click-able buttons in a GUI environment.
I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#
Interface Java can be used for a variety of tasks and commands such as .swf files, Java files, running scripts, as well as website video players for websites.
An mpp-1150 interface is used with the Atari computer serial interface that connects to a printer 36-pin Centronics connector.
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
No, it expects a serial port but does not specify voltages, impedances, wiring, etc. RS-232, RS-422, direct TTL levels, current loop, or any other hardware interface could be used, even a phone modem! The port DOES have to support full duplex with active messages in both directions at the same time. It does specify the commands and the protocol for the serial bus.
I am assuming you mean what is SCSI used for? In this case, SCSI does NOT mean "small computer serial interface," instead, it means "Small Computer SYSTEM Interface." SCSI is used as a fast interface between a host adapter and the CPU that can daisy chain as many as 7 or 15 devices on a single bus.
It is a very simple protocol used for transmission of IP datagrams across a serial line.
The RS 232 interface is one of the standards used in serial communications. It uses serial signals (as opposed to parallel) to connect computers to devices like printers and modems.