this is called a heat exchanger
with an open campfire it may not be a physical object
with an electric heater it may be miles away at a power plant
A combination boiler can use one of two different fuels to heat the water. Common combinations include natural gas/propane and oil, or wood and oil combinations. A condensing boiler uses a secondary heat exchanger to condense water vapour (steam) in the products of combustion down to water. Here's what that means: When any hydrocarbon (gas, propane, oil, even wood) burns, it gives off at least two "products of combustion. The carbon combines with oxygen to create CO2, carbon dioxide. The hydrogen combines with oxygen to create water vapour, or steam. (If combustion is "incomplete," there will be other trace products as well.) It's the water vapour or steam we're concerned with here. To boil 1 pound of water requires 960 BTUs of heat. Conversely, if you condense steam down into 1 pound of water, you will recover 960 BTUs. The fuel is burned in the "primary heat exchanger," where of course it releases a tremendous amount of heat into the water we're warming up. Then the "products of combustion" are drawn by a fan into the "secondary heat exchanger." When the water vapour or steam component of the products of combustion hits the relatively cool walls of this second heat exchanger, they condense down into liquid water. As they do, they release heat into the boiler water through the walls of the secondary exchanger. The liquid water then goes down a drain. Obviously, the boiler water has to be cooler than the steam component of the products of combustion in order for the heat to travel into it. So we make sure that this water is what's coming back to the boiler from the heating system. Again, for this method to work well, it's best applied in a "radiant in-floor" type heating system, where we don't heat the boiler water up to as high a temperature in the first place. --The HVAC Veteran
An ordinary furnace is not an engine at all, because it does not directly cause mechanical motion. The heat or expanding gases released in a furnace can be used to drive an engine, but that is a separate component from the furnace. If a furnace is used in this manner, the engine is an external combustion engine.
internal and external combustion engine
internal and external combustion engine
preheater is used to heat the air at Inlet of the furnace of Boiler By using Heat contents of Exhaust gases. This will minimize the fuel Consumption.
this is called a heat exchanger with an open campfire it may not be a physical object with an electric heater it may be miles away at a power plant
this is called a heat exchanger with an open campfire it may not be a physical object with an electric heater it may be miles away at a power plant
Products include heat, carbon, and water.
heat, smoke, toxic gases
A heat sink is a device or fixture that transfers heat from a component, such as the CPU or processor, it acts like a radiator in which it transfers the heat into the air. Aluminum is shaped by the extrusion process which is like squeezing tooth paste out of a tube.
heat can be one of the products as in a combustion reaction and it can be used as a catalyst
3CO2+8N2+4H2O+heat
Carbon dioxide, Water Vapor, and Heat
Mainly CO2 and H2O - Carbon Dioxide and Water. (Also heat, depending on if you are including it or not.) This can also be shown as an equation: Fuel + Oxygen → Carbon Dioxide + Water (and heat)
how does the heat of combustion of propane compare to the heat of combustion of paraffin wax
The triangle seen in combustion reactions on top of the arrow separating the reactants from the products is the Greek letter delta which means heat is added.
To combustion is to undergo combustion. Combustion is a process in which a substance reacts with oxygen to give heat and light.What are always the two products of a combustion reaction?A combustion reaction is when all substances in a compound are combined with oxygen, which then produces carbon dioxide and water.