Want this question answered?
As its name implies, a 'wattmeter' measures 'real' or 'true power'. It does this by measuring the supply voltage and the in-phase component of the load current.
In case of open circuit test of transformers we measure iron losses and hence the power lost here is being measured by the wattmeter.
There is no such thing as a 'low power-factor' wattmeter. A wattmeter always reads true power, regardless of the load's power factor.
Active volts amperes are measured by 2 wattmeter methods. A wattmeter will measure active power and not reactive power. Electrical engineering is a promising career for anyone who likes to generate power.
The 'one wattmeter method' can only be used for balanced, wye-connected, loads where the load's neutral point is accessible. The wattmeter's current coil is inserted into any line conductor, and the voltage coil is connected between the same line and the neutral point. The wattmeter reading indicates the power of one phase, so the total power is three times the wattmeter reading.To measure the total power of a balanced or unbalanced wye- or delta-connected load, it is only necessary to use twowattmeters -this is called the 'two wattmeter method'. In this case, the current coils of each wattmeter are inserted into any two line conductors, and the voltage coils are connected between the two line conductors and the third line conductor. The sum of the two wattmeter readings will indicate the total power of the load.
An energy meter measures power and time; a wattmeter measures an instantaneous value of power. Energy = Watt/seconds.
wattmeter
By definition, a wattmeter.
If you are asking whether power-factor improvement has any effect on a wattmeter reading, then the answer is no, it doesn't. Improving the power factor of a load has absolutely no effect on the power of the load, but it can act to reduce the value of the load current.
Wattmeter is an intrument which is used to measure the power consumption of an Electric circuit or an appliance which is connected to the supply in terms of Watts.
It's cheaper.
A wattmeter is designed so that it measures the supply voltage and the in-phase component of the load current. The product of these two quantities is the true power of the load.