Most vehicles have two flasher units. One for the turn signals and one for the hazards. If you have already replaced one try looking for the other one. Or check for a bad trunsignal switch
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
your flasher is bad replace it It's probably the turn signal signal switch in the steering wheel hub. They're junk from the factory.
Bad hazard switch.
Bad wiring i am guessing that something is wrong with your turn signal switch. Actually, The turn signals and hazard lights are controlled by 2 different relays. Try changing the Turn-signal relay.
Blown fuse
Are you sure you replaced the Turn Signal Flasher Relay? Some vehicles has a relay for the turn signals and one for the hazard lights. Possibly you changed the wrong one. It is also possible you purchased a new defective part. It happens although rarely.
The problem points to the directional/lights and hazard switch. The brake light wiring is part of that circuit.You can buy the switch after market it is about $70.00.
Check the brake switch at the pedal.
Check to make sure that ALL turn signals are working Could be flasher
If the lights come on but do not flash then the turn signal flasher relay is defective.
i had the same problem...turned out the hazard flashers button on top of steering column was in the wrong position ! ...talk about simplr..hope it works for you
Brake lights often use a dual-filament bulb. If this gets inserted the wrong way other functions can suffer.