When there is a code in the computer the engine runs on a set of specs and is not variable. Get the 02 fixed.
Where can i find a picture of the engine temp sensor location on a 1998 ford escort zetec engine?
1996 Ford Contour is sometime caused by a misfire on startup. The error will clear itself after 3 complet warm-up cycles not restarts.
I'm not sure which engine you have, but, the 2.0 has the camshaft sensor on the drivers side of the engine, right in front of the distributer
The camshaft position sensor (cam sensor) on a 1997 Ford Contour monitors the position of the camshaft to help the engine control unit (ECU) determine the correct timing for fuel injection and ignition. This sensor plays a critical role in optimizing engine performance, efficiency, and emissions by ensuring that the engine runs smoothly. If the cam sensor fails, it can lead to poor engine performance, misfires, or difficulty starting the vehicle.
1996 Ford Contour is sometime caused by a misfire on startup. The error will clear itself after 3 complet warm-up cycles not restarts.
on the front of the engine. it has a white wire on it and it screws in and out like a spark plug
near the #4 spark plug. 2.0L Engine
sensor is found on front of engine block above the harmonic balance wheel
check the crank shaft sensor under the engine near the starter motor.
On a 1996 Ford Contour, the temperature sensor, also known as the engine coolant temperature (ECT) sensor, is typically located near the thermostat housing on the engine block. It is usually positioned on the cylinder head or engine block, making it accessible for monitoring the engine's coolant temperature. To locate it, check near the intake manifold or the top area of the engine, usually on the driver's side. Always consult the vehicle’s service manual for precise location details.
It should be located on the top of the thermostat housing just at the right hand end of the engine. I am assuming that you are looking for the guage sensor.
vacuum leak or 02 sensor