A short within the relay coil itself.
The inverter draws little current on its own. It is the load that is connected to the inverter. If there were no load on the inverter you could use an ampmeter to determine the no load current. One thing to consider is that a higher wattage inverter would have larger gauge wire which is of lower resistance. This could make the no load current lower for the higher wattage inverter. Bottom line is you would have to measure or have a specification on the no load current.
The 2001 Honda Accord lower ball joint torque specification is 90 pounds. The lower ball joint should be torqued in 45 pound intervals.
The lower the value of the coefficient of friction, the lower the resistance to sliding.
alloying elements can be added to lower cost improve properties - it could be hardness, toughness, ductility, conductivity, corrosion resistance, pitting resistance etc
As temperature increases, the specific resistance of a wire typically also increases. This is because at higher temperatures, the atoms in the wire vibrate more vigorously, which disrupts the flow of electrons and increases the overall resistance of the wire. Conversely, at lower temperatures, the atoms have less thermal energy and are less likely to impede electron flow, resulting in lower resistance.
alloying elements can be added to lower cost improve properties - it could be hardness, toughness, ductility, conductivity, corrosion resistance, pitting resistance etc
No. The larger the conductor the lower the resistance and the higher the ampacity.
The lower leg pain could be caused by the fall that just happened. Also the lower leg pain could be a bruised bone or a bruised muscle. It could also be a fracture in the bone.
Gas
The lower the value of the coefficient of friction, the lower the resistance to sliding. A lower coefficient of friction means less force is needed to overcome the resistance between two surfaces, making sliding easier.
Around 30ft lbs.
If you measure a lower than normal total current in a parallel circuit, it could indicate that one of the branches in the circuit is experiencing higher resistance than the others. This could be due to a faulty component or a poor connection in that branch. It's important to investigate further to identify and address the specific cause of the discrepancy.