Distruibutor rotates clockwise on V6 & 4 cylinder. On 4 cylinder the #1 plug is front of engine. On V6 the # 1 plug is located passenger side front of engine.
yes
CHAIN - (Helpfull)
I ASSUME axle code " 86 " is the same as it is on the ( 1996 ) Ford Ranger ( 3.73 gear ratio , conventional / non - limited slip )
how do you change outer tie rods on a 1990 ford ranger
do a compression check on that cylinder. check fuel injector for pulse.
On my 86 2.0l it has a hydrallic clutch and there is no adjustment, but you can check the reservoir to see if there is enough fluid in it.
i think 46 psi
Ford Ranger
in many cases, contaminated brake fluid is the problem.
it depends on the vehicle but i replaced one on my 86 ford ranger an it was about $120 try shephard.com bout 100.00 or amautoparts.com
any shop with aldata,if they will print it out for you!! or you can go to aldata.com and get a subscription for your vehicle
Yes this is possible. There is a second set of spark plugs that fire shortly after the primary spark plugs fire to burn any remaining fuel out of the cylinder. This is done to lower emissions. This is a very common setup on the 2.3L Ford Ranger engine as well.