The question lists no factors, so
there was nothing to discover.
2 in parallel (= 10 ohms) and the third in series.
The law named after him is: V = IR (in words: voltage = current x resistance) It is more intuitive if you express it solved for current, since current can be thought of as the dependent variable: I = V/R This shows that more voltage will result in more current, while more resistance will result in less current. Of course, in the SI the units are chosen in such a way that the proportionality constant is one (and doesn't appear in the equation).
the answer is three
Georg Ohm was a German Physicist who developed the Ohm unit (Ω), the SI unit of electrical resistance.
name the main factors responsible for the differences in the three states of matter
Ohm detected the following one V = R * I Here V is the potential difference across a conductor. R- resistance of the conductor and I is the current that flow through the conductor.
the answer is current, voltage, and resistance
George Ohm, a German physicist.
2 in series with 3&4 in parallel
By discover of magnetic field hoped we helped
If the amplifier is designed for an 8 ohm load, then you should use an 8 ohm load. Three 8 ohm speaker in series is 24 ohms, and in parallel they are 2.67 ohms. Neither of those is a good match for an 8 ohm rated amplifier. If you do this, you will not achieve rated power, and you may well damage the amplifier.
Ohm discovered that, for some conductors, the current flowing through the conductor is directly proportional to the potential difference across them. This does not apply to allconductors -in fact, it applies to very few. Ohm's Lawstates that 'the current flowing in a wire is directly proportional to the potential difference across that wire, providing its temperature (as well as other factors) remains constant'.Ohm's Law makes no mention of resistance. The equation, R= V/I is derived from the definition of the ohm, and not from Ohm's Law, and applies whether Ohm's Law is followed or not. For Ohm's Law to apply, there must be a linear relationship between the ratio of V:I . Those materials that obey this rule are called 'ohmic' or 'linear', while those that do not obey this rule are called 'non-ohmic' or 'non-linear' -most materials are 'non-ohmic'.
2 in parallel (= 10 ohms) and the third in series.
Georg Simon Ohm was a German schoolmaster who discovered that for certain conductors, the ratio of voltage to current was constant for variations in voltage. He thought that this applied to all conductors, but this is not the case. In fact, Ohm's Law applies to very few conductors and, then, only under very specific conditions.
V=I*R OR R=V/I OR I=V/R AT constant temperature
V=I*R OR R=V/I OR I=V/R AT constant temperature
The factors of three are one and three.