0
What else can I help you with?
How do you remove the hydraulic line for the clutch in a 1995 Ford Explorer?
push in on line and push the plastic bushing that is on the connector up inside the connector itself to release it.
What to do if hydraulic bottle jack will not go down?
make sure it's full of oil
Why do they call it an Edison Connector?
http://buyextensioncord.com/info_Edison_connector.shtml
Why will the power steering not work on Kubota tractor?
if the foot pedal is operated with the tractor off, the hydraulic fluid can leak back out of the power steering pump. work the wheel back and forth for a minute or two to get fluid back into the steering box. also, check the hydraulic fluid level.AnswerThere is a brass connector between the hydraulic pump and the PS pump. This connector may have broken. or the end of shaft may have broken. This was the case with my L2250 DT
What do you call the connector that connects the hopper to the paintball gun?
The Feedneck.
What do you call a connector to a related webpage?
many names are used for this. the original name was 'link'
What do you call machines that use fluid to transmit and increase force?
A machine that runs of of fluid is called a hydraulic.
What is the little rod between the rocker and valve spring call on a 3.0 Plymouth engine?
That is the hydraulic lifter
Can I use hydraulic fluid for a substitute for hydraulic oil in a bobcat skid-steer?
Hydraulic fluid and hydraulic oil are one in the same.
Can hydraulic pump can be used as hydraulic motor?
Instead of hydraulic pumps, hydraulic gear motor does not work. Hydraulic pump hydraulic motor blade is used instead.
How do you add fluid to a Chrysler LeBaron convertible hydraulic motor?
HYDRAULIC PUMP ASSEMBLY LeBaron Convertible Review the complete service procedure before starting this repair. The convertible top on this model will raise slowly or make abnormal noise if the hydraulic fluid level is low. Disconnect the negative battery cable. Remove the sling well and floor cover from behind the rear seat. Disconnect pump wire connector and ground connection. Disconnect hydraulic lines from the pump assembly. Remove the motor pump assembly from the vehicle. The rubber mounts are pressed and locked into the mounting bracket. Pull up motor assembly to remove. To install: Position the motor assembly in the vehicle. Connect the hydraulic lines to the pump assembly. Attach the pump wire connector and ground connection. Install the sling well and floor cover behind the rear seat. Connect the negative battery cable. Fill the pump reservoir with Dexron
Is a 2001 Mitsubishi eclipse have a hydraulic or cable clutch?
Hydraulic Hydraulic
