0
What else can I help you with?
How do you change the wheel bearings on your ford cougar?
well.you dont have to..theyre set from the factory and cant be packed..nice huh?
How do you reset the traction control on a 2000 olds alero?
you cant bad speed senser in one of the wheel bearings is abs light on?
Why cant you rollerblade in the rain?
its not that good for your rollerblades it can cause the wheel bearings to rust but i say why not you're not sugar you're not going to melt
How do you change the front wheel bearings on a 19999 Saturn SC?
The bearings are pressed into the knuckle so you have to remove the knuckle and then press out the hub (wheel studs) and then remove the clip and press out the bearing cant do it unless you have a 10 tonne press
Why cant you buy a front hub assembly for a 97 mercury villager?
Because it doesn't have one. The wheel bearing is a separate part that is installed into the spindle assembly.
How do you put the spindel back on the front of 4x4 new balljoints on cant put back on?
To reinstall the spindle on new ball joints for a 4x4, start by ensuring the ball joints are properly seated in their respective control arms. Align the spindle with the ball joint studs and gently tap it into place with a rubber mallet if necessary. Ensure the spindle is correctly oriented and that any alignment marks match up. Finally, secure the spindle by tightening the nut to the manufacturer's specified torque.
How do you adjust the steering gear box on a 1984 ford e250?
u cant make sure wheel bearings and all other suspition is tight
How do you grease the front bearings on a 1998 Pontiac Bonneville?
Cant They are a sealed, non servicable unit. If they are making noise, they must be replaced, about $135 each
What would make a humming or grinding sound when im inside the car driving but cant be heard on the outside?
if its while your driving it could be wheel bearings
How do you change a front wheel bearing on 1993 Toyota Celica?
1st: Go buy a wheel bearing from a auto part store. About $25-$60, depend which brand you want. Or buy a used spindle but make sure the wheel bearing is good! It'll cost you around $25-$150. This is a better deal, i'll tell you why later. 2nd: IF you buy a new wheel bearing; Take your spindle to a shop that can press out and press in the wheel bearings, this will cost you around $40-$100 total per bearing. Wala! you have a brand new wheel bearing. Estimate waiting time is 30Min-couple hours. IF you bought a used spindle, just take out your old one and install the new used spindle in. This is free of charge lol. This way is cheaper but it is a risk. Just in case you cant find a 93 celica used parts. All 90-93 are interchangeable parts, doesn't matter what trim it is. They all will fit as long as it is from a 5th generation celica. Keep this in mind though, the 90's celica will fit perfectly BUT their rotors are slightly smaller so meaning their spindle could be a little smaller. And do make sure when you are putting back in the spindle DO NOT mess up your tie rod and bushings.
I have a car seat for my two year old and i cant get some melted hard candy out of it can anyone help?
buy a new car seat and dont let him eat candy in it
You just replaced the clutch in your yz490 and you cant get it to disengage is it because the adjustment screw is not right?
On mine I h.ad the same prob. Got hot enough to weld the clutch rod to the bearings
