What transmission are you talking about
In most cases you would use some sort of end code, signoff code, EOT (end of transmission) code, end transmission signal. It depends on the transmission method or transmission protocol or transmission media.
Alternating current is better than direct current for transmission.
characteristic of end-to-end data transmission
Line current = 10MW / 500kV = 20A Assuming the 1000 ohms is the resistance of the entire transmission line, end to end. Power loss = line current ^ 2 * line resistance = 20A ^ 2 * 1000 ohms = 400 KW
Transmission Lines are an example of electic current
is a type of transmission that has no beginning and no end
It is on the output end of the transmission.It is on the output end of the transmission.
End-Transmission - 2000 was released on: USA: 2000
Only if it is a DC transmission line.
Transmission Lines are an example of electic current
A: The main advantage for a current source transmission is low source impedance. extraneous voltage influence is reduced by that characteristic.
transmission lines
The leakage current in underground transmission line are any two conductors separated by an insulating medium. It constitutes a condenser and a capacitor.